Install the dome drive: |
|
4 a. Set the DIP switches located on the side of the dome drive. |
|
Refer to the labels located on the top of the dome drive or to |
|
the Quick Start Guide shipped with the dome drive. | SW1 SW2 SW3 |
NOTE: No DIP switch settings are required for Coaxitron control.
b. Line up the blue (A) and red (B) tabs with the blue (A) and red (B) labels.
c. Push in on the tabs. Insert one side and then the other side. Continue pushing until both sides of the dome drive click into place.
5 Install the lower dome:
a. Position the lower dome so that the blower duct inside the back box is between the studs attached to the inside of the lower dome.
b. Install the
c. Test and check the operation of the unit before pressurizing the dome.
English
6 Pressurize the inside of the dome with nitrogen:
a. Remove the cap from the Schrader valve of the dome. Place the air chuck from the charging kit over the Schrader valve of the dome system.
NOTE: You may use your own charging equipment or Pelco’s EH8000RKIT recharge kit. If you are using your own equipment, adjust the regulator for an output pressure of 12 psi (83 kPa).
b.Open the tank valve of the charging kit. Fill the dome with nitrogen for a minimum of five minutes to replace the oxygen inside the dome with nitrogen.
c.Remove the air chuck and then replace the Schrader valve cap.
d.Refer to the Operation/Programming manual for instructions on how to view the current readings for the temperature and pressure. Record the initial temperature and pressure readings of the dome in the space provided below:
Initial Temperature _______________
Initial Pressure _________________
IMPORTANT: Record the initial temperature and pressure read- ings for future reference.
NOTE: It is normal for changes in temperature to cause dome pressure to rise and fall.
5 |