Pelco C2410M-J manual Regulatory Notices, Radio and Television Interference

Page 4
Regulatory Notices

Regulatory Notices

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1)this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Radio and Television Interference

This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However there is no guarantee that the interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and the receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

You may also find helpful the following booklet, prepared by the FCC: “How to Identify and Resolve Radio- TV Interference Problems.” This booklet is available from the U.S. Government Printing Office, Washington D.C. 20402.

Changes and Modifications not expressly approved by the manufacturer or registrant of this equipment can void your authority to operate this equipment under Federal Communications Commission’s rules.

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

4

C2410M-J (2/08)

Image 4
Contents 150 Series Camclosure Integrated Camera System C2410M-J2/08In-CeilingMount I N S T A L L A T I O NContents Important Safety Instructions Regulatory Notices Radio and Television InterferenceInstallation INSTALL BACK BOXDescription MOUNTING DIRECTLY TO A WALL OR CEILINGINSTALL CAMERA MOUNTING TO CEILING TILEINSTALL DOME AND TRIM RING Turn on power to the camera and monitorNOTE The screws are installed at an angle Proper camera orientationAdjustments VERTICAL PHASE 24 VAC OPERATION ONLYGENERAL SpecificationsELECTRICAL WARRANTY PRODUCT WARRANTY AND RETURN INFORMATIONRETURNS REVISION HISTORY Manual #Date CommentsWorldwide Headquarters 3500 Pelco Way Clovis, California 93612 USA USA & CanadaTel 800/289-9100 Fax 800/289-9150 International Tel 1-559/292-1981 Fax 1-559/348-1120