3.If the heater is installed, plug the heater connector from the camera into the mating connector inside the base. Plug the video connector from the camera into the mating connector inside the base.
Turn on power to the camera and monitor.
VIDEO
CONNECTOR
HEATER
CONNECTOR
4.Always make sure the tab on the camera bracket is pointing out of the enclosure (away from the ceiling or wall). Gently squeeze the bracket, place it against the shoulder inside the back box, and then gently release.
Proper camera orientation:
CAMERA BRACKET
TAB ALWAYS POINTS 
OUT OF THE
ENCLOSURE
Ceiling Mounting: The camera bracket tab points out of the enclosure, and the top of the camera is pointed in the opposite direction.
TOP OF
CAMERA
CAMERA BRACKET
TAB ALWAYS POINTS
OUT OF THE
ENCLOSURE
Wall Mounting: The camera bracket tab points out of the enclosure, and the top of the camera points up towards the tab.
INSTALL DOME AND TRIM RING
Place the trim ring and dome over the back box. If the dome has a liner, position the viewing window over the lens of the camera. Tighten the
NOTE: The screws are installed at an angle.
7 |