The radio
1 | 2 |
Press [INPUT SELECTOR < or >] | Select the frequency. |
to select “TUNER FM” or “TUNER | Auto tuning starts if you press and |
AM”. | hold the button. |
The radio
Direct tuning
Input the frequency of the station.
Remote control
1.Press [TUNER, ―BAND] to select “TUNER”.
2.Press and hold [TUNER, ―BAND] to select “TUNER
FM” or “TUNER AM”.
3.Press [TUNER DIRECT TUNING].
4.Press the numbered buttons to enter the
frequency.
e.g. To select 107.9 MHz, press [1] → [0] → [7] → [9]
•If you do not press a button while the cursor is flashing, the display returns to the frequency being received.
•If the frequency has not been input correctly, “ERROR” will be displayed.
Automatic presetting
The FM stations the unit can receive are preset in channels 1 to
30.The AM stations the unit can receive are preset in channels
21to 30 (FM stations are replaced if any were preset in these channels).
Preparation: Tune to either FM 87.9 MHz or AM 530 kHz.
Main unit
1.Press
2.Press [TUNE 2 / - or 1 / +] to select “START”
➡[ENTER].
Select “CANCEL” to cancel.
The tuner presets all the stations it can receive into the channels in ascending order.
During automatic presetting, the memory indicator (M) flashes and the frequency scrolls. The memory indicator and channel numbers are displayed for a second when a station is preset.
The last station to be preset is displayed when presetting finishes.
Manual presetting
Preset the stations one at a time.
Preparation: Tune to the station you want to preset.
Main unit
1.Press
2.Press [TUNE 2 / - or 1 / +] to select the channel
➡[ENTER]. (“STORED” lights.)
For your reference
FM stations can also be preset in the MONO mode.
Selecting channels
Remote control
1.Press [TUNER, ―BAND] to select “TUNER”.
2.Press [SKIP u, 2 or i, 1].
or
Press the numbered buttons.
For channels 1 to 9, press the corresponding number. For channels 10 or over, press [ ≧10], then the two digits. e.g. To select channel 21: [ ≧10] → [2] → [1]
Main unit
1.Press
2.Press [TUNE 2 / - or 1 / +] to select “PRESET”
➡[ENTER].
Select “MANUAL” to cancel.
3.After exiting the menu:
Press [TUNE 2 / - or 1 / +].
Reducing excessive noise
During FM stereo reception
You can improve FM reception by switching reception to monaural.
Main unit
1.Press
2.Press [TUNE 2 / - or 1 / +] to select “MONO”
➡[ENTER].
Select “AUTO” to cancel.
During AM reception
When there is a lot of noise interference with an AM broadcast, try switching this mode.
Main unit
1.Press
2.Press [TUNE 2 / - or 1 / +] to select “MODE 1” or “MODE 2” ➡ [ENTER].
RQTX0175
17