SkyLink Emergency Dialer Dial-Alert, AD-433S manual Battery Maintenance, Additional Accessories

Page 13

BATTERY MAINTENANCE

The AD-433S Dial-Alertcomes with 1 battery that at some point you may have to replace:

One

9 volt alkaline battery for the Dial-Alert

Recommendation: Test your Dial-Alertperiodically to ensure that the battery is working.

Dial-Alert Battery

The Dial-Alertcomes equipped with a 9V backup battery in case the elec- trical power is interrupted for any reason.

When the dialer backup battery is low, the LOBATT. light goes on.

To replace the dialer backup battery:

1. Undo the two screws on the back of the Dial-Alert.

2. Open the Dial-Alertcase by pressing down on the two tabs on the top edge and pull the front forward.

3.Disconnect the old battery.

4.Connect the new battery.

5.Close the Dial-Alertcase and re-insert the two screws.

The battery life, (9 volt alkaline battery), is approximately two years if used only for backup.

Note: If the AC adapter is disconnected while the battery is being replaced, the pre-recorded message will be erased, and the clock will return to 12:00. Re-record the emergency voice message and reset the clock. (Refer to page 10). The pre-programmed phone numbers will not be erased even the power is disconnected.

–23–

ADDITIONAL ACCESSORIES

Additional sensors and transmitters as well as add on accessories are available to work with your Dial-Alert.

Motion Sensor (PS-433A)

-Monitors area in a 110 degree ARC and up to 40 feet away from the sensor

-9V alkaline battery included

Door/Window Sensor (WT-433)

-Attaches to all doors, windows, entrances

-Add on as many magnetic switch (MS-001) as needed

-12V alkaline battery included

Magnetic Switch/Magnet (MS-001)

-Used in conjunction with Door/Window Sensor (WT-433)

-Add on for additional doors, windows

Keychain Transmitter (4B-434)

-Activates Security Control Panel (SC-001) instantly by pressing panic button

-Arm/Disarm Security Control Panel (SC-001)

-Reliable design, crystal base transmission with microcontroller

-12V alkaline battery included

Audio Alarm (AA-433)

-Additional indoor/outdoor siren

-Water resistant

-120 dB siren with flashing LED

-Operates by AC adapter with 9V alkaline back up battery (included)

–24–

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Emergency Dialer Emergency Dialer Package Contents Table of ContentsHow to use the template InstallationInstalling the DIAL-ALERT AD-433S OverviewTone/Pulse Switch Switch SettingStandard Programming Lights and SoundsStoring Telephone Numbers Playback PRE-RECORDED MessageActivate the DIAL-ALERT with the Panic Button on the Keypad Delete a Telephone Number from MemoryProgram the Calling Time Advanced ProgrammingProgramming a Pause Period SET the Type of Phone SystemProgram the ID Code of a Transmitter Delay Dialing Entry / Exit ModeDelete Programmed TRANSMITTERS/SENSORS/SECURITY Systems To ARM/DISARM the DialerTo set the dialing delay Entering a premises using the delay dialingDial Sequence Setting To program the Dial Sequence SettingConnect the DIAL-ALERT with Your Existing Alarm System Additional Accessories Battery MaintenanceDial-Alert Battery To replace the dialer backup batteryTemperature Sensor TS-433 Silent Alarm SW-433Security Control Panel SC-001 Vibration Sensor VS-433
Top Page Image Contents