STANDARD PROGRAMMING
C. Storing telephone numbers in memory (Sends the numeric information to pager only)
1.Press the [MEM] key, the display will show a letter “M” on the upper left corner. If nothing is entered within 5 seconds, the display will return to the clock mode.
2.Within the first 5 seconds, select a memory location by pressing a keypad number 1 - 9 to store the telephone number.
3.Enter the telephone number using the keypad. The display will flash as the telephone is being entered. To insert a pause period between any digits of the
4.Enter the numeric information you want to send out, ( the information that will be shown on the pager), then press [L]. This will suspend the recorded message.
5.Press [MEM].
6.After the telephone number has been stored, another message will appear on the display asking for a redial count. The redial count is the number of times the dialer will call that telephone number. The dialer is factory set to call the number 3 times. The number of attempts can be changed to dial 1 to 9 times. If you want to keep the redial count at 3 attempts, press the [MEM] key. To change the redial count, enter a number from 1 - 9 when display shows "rEdIAL 3".
7.Input the repeat times when the display shows "rEPEAt 3". The repeat time is the number of times the message will be played for that certain phone number. The current setting is 3. It can be changed from 1 to 9 using the keypad. Again, by pressing [MEM] will keep the existing setting.
DELETE A TELEPHONE NUMBER FROM MEMORY
1.Press [MEM] key.
2.Select the memory location (1 - 9) of the phone number you want to delete.
3.The phone number will be shown on the display, if that is the number you want to delete, press the [R/P] key while the telephone number is on the display. Once the phone number is deleted, the display will return to clock mode.
STANDARD PROGRAMMING
TO REVIEW OR MODIFY THE
1.Press the [MEM] key, display will show an “M” in the upper right corner.
2.Select the memory location of the phone number, (1 - 9)
3.The phone number will be shown on the display.
4.If you want to change the telephone number, enter the new phone number while the old number is on the screen. This telephone number will be deleted when a new number is added. Then press the [MEM] key. If you want to keep the telephone number shown on the screen, press [MEM].
5.The display will now show the current setting of the redial count. If you want to keep the current redial count, enter the [MEM] key. If you want to change the setting, enter the desired number, (1 - 9), then press the [MEM] key.
6.After pressing the [MEM] key, the display will show the current setting
of the repeat times.
7.If you want to keep the current repeat time, enter the [MEM] key. If you want to change the setting, enter the desired number, (1 - 9), then press the [MEM] key.
8.The screen will revert back to clock mode.
ACTIVATE THE DIAL-ALERT WITH THE PANIC BUTTON ON THE KEYPAD
After you programmed all the emergency telephone numbers and the voice message, you can activate the dialer by pressing the panic button on the keypad. Once the panic button is pressed, the dialer will start dialing the pre- programmed emergency phone numbers. You can also activate the dialer using the Panic Transmitter.