INSTALLATION
Screwing the unit to the wall
1.Unscrew the two triangular hanging tabs located at the back of the Audio Alarm.
2.Turn them around and slide them back into place so that the two tabs are pointing up and the two keyholes are visible from the front.
3.Position the Audio Alarm on the wall and insert the two screws in the two keyholes. Do not insert the screws all the way into the wall, leave some room on the screw to hang the Audio Alarm. Use the template if needed.
4.Open the small door on the bottom of the Audio Alarm.
5.Insert the AC adapter and the antenna in the appropriate holes.
6.Close the small door so that the AC adapter and the antenna are running through the appropriate spaces in the door.
DELETE SENSORS AND TRANSMITTERS
You cannot delete one sensor/transmitter from the Audio Alarm at a time. You must clear all the sensors and transmitters that are currently communicating with the Audio Alarm, then
Delete All Sensors and Transmitters
1.Turn the Audio Alarm off by sliding the switch on the
bottom of the Audio Alarm so that the “ON” light is not lit.
2. Press and hold the learn button found on the bottom of the Audio Alarm.
3.While holding the learn button, turn on the Audio
Alarm by sliding the switch on the bottom.
4. You will hear a long beep followed by a series of short beeps. When you hear the short beeps, re- lease the learn button.
You have now cleared all sensors and transmitters from communicating with the Audio Alarm.
|