American Standard 6044.XXX Test Installed Fitting, Check Drain Connections, Care Instructions

9TEST INSTALLED FITTING

With HANDLES (1) in OFF position, turn on WATER SUPPLIES (2) and check all connections for leaks.

Remove AERATOR (3) by turning counter-clockwise using AERATOR KEY (3a).

Operate both HANDLES (1) to flush water lines thoroughly.

Replace AERATOR (3) turning clockwise using

AERATOR KEY (3a).

CHECK DRAIN CONNECTIONS

Operate POP-UP KNOB (4) and fill lavatory with water. Check that DRAIN STOPPER (5) makes a good seal and retains water in SINK. If DRAIN STOPPER (5) does not seal properly, please refer to Troubleshooting section in these instructions.

Release POP-UP KNOB (4) down and check all drain connections and "P" trap for leaks. Tighten

if necessary.

1 4

1

3 3a

5

WASTE

OUTLET

2 “P” TRAP 2

10 SERVICE

To change direction of handle rotation, proceed as follows:

To change direction of handle rotation, proceed as follows:

Turn valve to OFF position.

Rotate HANDLE ESCUTCHEON (1) counter-clockwise and pull off of ADAPTER (2).

Remove ADAPTER SCREW (3) and ADAPTER (2).

Remove SPRING CLIP (4).	4
Lift STOP WASHER (5), turn 90˚ and replace.
Replace SPRING CLIP (4).

Replace ADAPTER (2) and ADAPTER SCREW (3).

1
90˚
5	3
	2

Align HANDLE and push onto ADAPTER (2).

Turn HANDLE ESCUTCHEON (1) clockwise to tighten.

AERATOR (6) may accumulate dirt causing distorted and	6
reduced water flow. Remove AERATOR (6) and rinse clean.

See Step 9 for removing AERATOR (6).

If spout drips, operate handles several times from OFF to ON position. Do not force - handles turn only 90˚.

11 CARE INSTRUCTIONS:

DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.

DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A CLOTH WITH A COARSE SURFACE.

M 9 6 8 6 8 8

4