INSTALLATION INSTRUCTIONS
INSTALLATION
5.6.4Place the remaining 4 large coals or pebbles on top of the square blocks, ensure that they lean against the central small coal or pebble and that there are gaps between each coal or pebble. See diagram 17.
17
AR1273
5.7 Log & Driftwood Layout – Small Aspen & Chamonix
It may be necessary to make small changes to the log positioning in order to achieve the most pleasing flame effect but the following guidelines should be followed.
5.7.1Refer to the log identification chart and identify the numbers corresponding to the logs that have been supplied. See diagram 18
18
8
5.7.3Place the large log (No. 1) so that it sits on top of the previous two logs. Place the burnt effect log (No. B1) in the centre of the tray as shown. See diagram 20.
20
AR1275
5.7.4Place log (No. 7) along the LH side of the tray, log (No. 9) along the RH side of the tray and place logs (No. 8 and 11) along the front of the tray as shown. Place the cone (No. 14) on the LH side of the burnt log. See diagram 21.
21
AR1276
5.7.5Place the large log (No. 6) so that it rests on top of the rear and front logs to the LH side, Place log (No. 7) on the RH side and log (No. 8) so that it bridges the centre gap as shown. See diagram 22.
22
5.7.2Place the two logs (No.13) on top of the beads as shown. See diagram 19.
19
AR1277
AR1274
19