SERVICING INSTRUCTIONS
REPLACING PARTS
1.FIRE REMOVAL
1.1Turn the gas supply off at the isolation device, remove the decorative ashpan cover and disconnect the gas supply pipe from the inlet.
1.2Carefully remove all the loose ceramic fuelbed pieces and place on a dry clean surface.
1.3Remove the outer decorative basket and place to one side.
1.4Undo the two screws securing the fire to the hearth. See diagram 1.
1
1.5Lift the fire away from the hearth and carefully tip the firebeads (or glass granules if applicable) into a dry clean container for later replacement.
2.IGNITION LEAD
2.1It should be possible to replace the ignition lead without removing the fire, if this proves difficult the the fire should be removed, see section 1.
2.2Undo the screw thar secures the
2
2.3To release the right hand side of the control cover insert a narrow blade screwdriver into the slot shown in diagram 3, lever it gently and pull from the right hand side at the same time. The cover will now come off, there is a small cylindrical spacer inside the cover, this must be kept and replaced on the fixing screw during
3
2.4Disconnect the ignition lead from the gas valve and gently pull the other end off the pilot electrode. See diagram 4.
4
26