INSTALLATION INSTRUCTIONS
INSTALLATION
5.9 Log & Driftwood Layout – Tahoe
It may be necessary to make small changes to the log positioning in order to achieve the most pleasing flame effect but the following guidelines should be followed.
5.9.1Refer to the log identification chart and identify the numbers corresponding to the logs that have been supplied. See diagram 28.
28
8
5.9.2Place a cone (No. 14) in the centre at the rear edge of the tray and place one log (No. 13) at each side of the cone. Place one log (No. 11) along the front of the tray at each side of the pilot. See diagram 29.
29
AR1282
5.9.3Place the burnt effect log (No. B1) in the centre of the tray. See diagram 30.
30
5.9.4Place one log (No. 8) in the centre so that it rests on the rear cone and the pilot shield. See diagram 31.
31
AR1284
5.9.5Place one log (No. 11) so that it rests on the LH front log and the burnt log. Place another log (No. 7) so that it rests on the RH front log and the burnt log. See diagram 32.
32
AR1285
5.9.6Place the two thin logs (No. 12), one at each side sitting on the tray and resting against the previously positioned logs. Place one log (No. 9) at the LH rear resting on the base log, and one log (No. 8) at the RH rear. See diagram 32.
33
AR1286
AR1283
21