Napoleon Grills GDS 50-P, GDS 50-N, GS 50-P, GS 50-N manual GAS-FIRED Stoves

Page 1

1

INSTALLER: THESE INSTRUCTIONS MUST BE CONVEYED TO AND REMAIN WITH THE HOMEOWNER.

CERTIFIED UNDER CANADIAN AND AMERICAN NATIONAL STANDARDS, CSA 2.33, ANSI Z21.88 FOR VENTED GAS FIREPLACE HEATERS

GAS-FIRED STOVES

INSTALLATION AND OPERATION INSTRUCTIONS FOR:

VENTED GAS FIREPLACE HEATER

NATURAL GAS MODELS PROPANE GAS MODELS

GDS 50-N GDS 50-P

NATURAL GAS MODEL PROPANE GAS MODEL

GS 50-N GS 50-P

CERTIFIED FOR CANADA AND UNITED STATES USING ANSI / CSA METHODS

WARNING: If the information in these instructions is not followed exactly, a fire or

explosion may result causing property damage, personal injury or death.

FOR YOUR SAFETY

Do not store or use gasoline or other flammable vapours and liquids in the vicinity of

this or any other appliance.

WHAT TO DO IF YOU SMELL GAS:

• Do not try to light any appliance.

• Immediately call your gas supplier

• Do not touch any electrical switch.

from a neighbour's phone. Follow the gas

 

Do not use any phone in your building. supplier's instructions.

If you cannot reach your gas supplier, call the fire department.

Installation and service must be performed by a qualified installer, service

agency or the gas supplier.

Wolf Steel Ltd., 24 Napoleon Rd., Barrie, ON L4M 4Y8 Canada • (705)721-1212fax(705)722-6031

www.napoleonfireplaces.com • ask@napoleon.on.ca

W415-0098 / A / 08.07.03

Image 1 Contents
GAS-FIRED Stoves Table of Contents Napoleon GAS Fireplace Presidents Lifetime Limited Warranty General Information General InstructionsCare of GLASS, and Plated Parts GDS50 and GS50 Location & ClearancesVenting Lengths AIR Terminal Locations Direct Vent Specifics Model GDS50AIR Terminal Installations Special Installation Example Offset Installation ExampleHorizontal Wall and Ceiling Protection Horizontal Installation Vertical InstallationW415-0098 / a Stove Vent Connection Mobile Home Installation Continue with Gas InstallationInstalling B Vent Chimney InstallationVent Specifics Model GS50 Adding Vent SectionsVent Adaptations Installing Flashing Storm CollarCombustion AIR TWO Screws Must be RE-SECURED. FigureGAS Installation Finishing Trivet InstallationDoor Opening and Closing Mantle ClearanceLOG Placement Spill Switch Operation / MaintenanceTurbo Burner Operation Maintenance Operating InstructionsFor Your Safety Read Before Lighting Blow Replacement Blower InstallationPilot Burner Adjustment AdjustmentsVenturi Adjustment Front Burner Rear Burner# Description ReplacementsPage Symptom Problem Test Solution Trouble Shooting GuideModel GDS50 only