Peavey operation manual Specifications DU Transtube 110 EFX

SPECIFICATIONS DU TRANSTUBE® 110 EFX

POWER AMP SECTION:

Rated power and load:

40 Watts (RMS) into 6 Ohms

Power @ clipping (typically): (5% THD, 1 kHz, 120 VAC line) 35 Watts (RMS) into 6 Ohms

Total harmonic distortion:

Less than 0.5% THD, 100 mW to 15 Watts (RMS), 100 Hz to 10 kHz

Power amp hum and noise @ nominal input level:

(20 Hz to 20 kHz, unweighted) Greater than 82 dB below rated power

Power Consumption:

75 Watts 50/60 Hz, 120 VAC

PREAMP SECTION:

The following specs are measured @ 1 kHz with the controls preset as follows: Channel select: CLEAN

EQ voicing switch: MODERN

Low, mid, and high: 5

Pre gain and post gain: 10

Efx adjust: OFF

Reverb: OFF

Delay: OFF

Volume (nominal level): 5

Volume (minimum level): 10

Preamp input (clean channel):

Impedance: High Z, 250 k Ohms

Nominal input level: -14 dBV, 200 mV (RMS)

Minimum input level: -24 dBV, 64 mV (RMS)

Effects send:

Output impedance: 1k Ohms

Nominal output Level: -7.4 dBV, 425 mV (RMS)

Effects return:

Input impedance: 31 k Ohms

Nominal input level: -7.4 dBV, 425 mV (RMS)

Headphone output:

Load impedance: 8 Ohms or greater

Nominal Power Output: 30 mW (RMS) into

8 Ohms

(Stereo jack, monaural signal disconnects internal speaker when phone plug is inserted.)

System Hum and noise @ nominal input level:

(20 Hz to 20 kHz, unweighted) Greater than 75 dB below rated power

Les spécifications sont sujettes à modification sans avis préalable.

17