13
Front Panel
13 |
| 10 | ||
|
|
|
|
|
|
|
|
|
|
6
7
10 | 8 | 9 | 11 | 12 | 14 | 15 | 16 | 17 |
Input jack will accept signals from all types of guitar pickups. Be sure to use a high quality shielded instrument cable to connect the guitar to the amplifier.
(7) VOLUME
Controls the volume level of the Clean channel and is not affected by the Lead, Pre or Post Gain controls.
(8) PRE GAIN
Controls the input volume level of the Lead channel. The Pre Gain can be used to control the distortion level in the Lead channel. To obtain more distortion simply increase the Pre Gain and set the Post Gain (9) to the desired volume level.
(9) POST GAIN
Controls the overall volume level of the Lead channel. The final level adjustment should be made after the desired sound has been achieved.
(10) MODERN/VINTAGE SWITCH
This switch allows you to instantly change the voicing to reflect the tones of modern and vintage amplifiers. The MODERN position maintains a warm, standard voicing. The VINTAGE position changes the overall function of the EQ and adds a hint of brightness to emulate some classic amp designs. Experiment with this switch, along with the EQ (11) adjustments, to capture your desired tone. You may refer to the Recommended Settings on page 6 for some creative starting points.
(11) LOW, MID AND HIGH EQ
Passive tone controls that regulate the low, mid and high frequencies, respectively.
(12) CHANNEL SELECT
This switch selects the channel (Lead or Clean). The ACTIVE CHANNEL LEDs (13) indicate the active channel
— green for Clean; red for Lead.
(13 ACTIVE CHANNEL LEDs
These indicators signify the active channel. Green indicates Clean channel activation; red indicates Lead channel activation.
(14) EFX ADJUST
Pressing this control selects the effect. A yellow LED adjacent to the effect name will illuminate to indicate the selected effect. Rotating this control clockwise changes the parameter of the active effect according to the descriptions below. The surrounding LED ring indicates relative value of the parameter being adjusted.
EFX ADJ PARAMETERS |
|
Tremolo - Rate increase | Funk Wah - Sensitivity increase |
Octaver - Wet/Dry mix | Rotary Speaker - Rate increase |
Flanger - Rate increase | Phaser - Rate increase |
Chorus - Rate increase/depth decrease |
|
EFX amps are built with factory settings loaded into the presets. To return to the factory settings, press and hold both the EFX ADJUST (14) and DELAY (16) controls while turning the amp on.
(15) REVERB
6