TECHNISCHE DATEN DES TRANSTUBE® 110 EFX
POWER AMP SECTION:
Rated power and load:
40 Watts (RMS) into 6 Ohms
Power @ clipping (typically): (5% THD, 1 kHz, 120 VAC line) 35 Watts (RMS) into 6 Ohms
Total harmonic distortion:
Less than 0.5% THD, 100 mW to 15 Watts (RMS), 100 Hz to 10 kHz
Power amp hum and noise @ nominal input level:
Volume (minimum level): 10
Preamp input (clean channel):
Impedance: High Z, 250 k Ohms
Nominal input level:
Minimum input level:
Effects send:
Output impedance: 1k Ohms
Nominal output Level:
Effects return:
Input impedance: 31 k Ohms
Nominal input level:
(20 Hz to 20 kHz, unweighted) | Headphone output: |
Greater than 82 dB below rated power | Load impedance: 8 Ohms or greater |
| Nominal Power Output: 30 mW (RMS) into |
Power Consumption: |
|
75 Watts 50/60 Hz, 120 VAC | 8 Ohms |
| (Stereo jack, monaural signal disconnects |
PREAMP SECTION: | internal speaker when phone plug is inserted.) |
The following specs are measured @ 1 kHz |
|
with the controls preset as follows: | System Hum and noise @ nominal input |
Channel select: CLEAN | level: |
EQ voicing switch: MODERN | (20 Hz to 20 kHz, unweighted) |
Low, mid, and high: 5 | Greater than 75 dB below rated power |
Pre gain and post gain: 10 |
|
Efx adjust: OFF |
|
Reverb: OFF |
|
Delay: OFF |
|
Volume (nominal level): 5 |
|
Änderungen der technischen Daten vorbehalten.
29