Marmitek SD90 user manual General Information and Function, Application, Activating the sensor

11.	Changing the address of the smoke alarm	7
12.	Frequently Asked Questions	7
13.	Technical data	7

1 GENERAL INFORMATION AND FUNCTION

The smoke detector can detect incipient low temperature fires and open fires with smoke development and can be installed in any room. The smoke detector operates by the optical principle. There are no radioactive substances in this detector.

The smoke detector incorporates the following features:

•It monitors rooms for the development of smoke.

•It has an integrated signal transmitter.

•Your Marmitek Alarm System dials out, even if your security system is not armed.

2 APPLICATION

The radio smoke detector is intended for the detection of smoke in interiors by the use of optical and acoustic warnings, as well as wireless transmission over distances of up to 30 meters. In combination with the HomeGuard MS8000 the range is up to 10 meters. Range may vary due to battery and temperature conditions. The SD90 smoke detector does not sense gas, heat or smokeless flames! The equipment may not be modified under any circumstances.

Activating the sensor:

1.Remove the mounting bracket from your unit by rotating it counter-clockwise.

2.Connect the battery

3.Press the Reset button for a short period (4)

4.The yellow LED will blink twice

☺If the yellow LED blinks more than twice, reset the smoke alarm to the factory setting. (See chapter 10.)

3 REGISTERING THE SMOKE DETECTOR WITH THE SC9000 BASE STATION OF THE SAFEGUARD / TOTALGUARD

Carry out the following steps:

1. To access the menu, press the menu or menu button. The display will now read ‘ENTER PIN’.

2.Enter your 4-digit PIN code (factory setting 0000). For every digit entered, a * will appear on the display.

3.When the PIN code has been entered correctly, the word ‘INSTALL’ will show up on the display.

4.Press OK.

5.Press the Test button (1) on the smoke alarm until the smoke alarm emits an audio signal. The console will respond with a beep. The display will read “RMOT x SET”.

6.Even If you are using more than one smoke detector you only have to register the first one.

7.Press CLEAR to go back to the main menu. Press CLEAR again to quit the menu.

4 REGISTERING THE SMOKE DETECTOR WITH THE BASE STATIONS OF THE TYPES MS9470, MS9770, MS9970, SC2200, SC2700, SC2800, PROTECTOR 28

Carry out the following steps:

1.Open the lid on the right side of your security system’s base station.

2.Set the mode switch to the INSTALL position. All indicators of occupied zones will come on.

3.Press the Test button on the smoke alarm (1) until the alarm emits an audio signal. Your console will

4 © MARMITEK