Hunter Fan 82043, 43045 manual C9C10, C12

Page 11

C7

Insert mounting screws, leaving space between the screw

head and the joist. (Screws are supplied.)

C8

Attach the rails onto the screws.

C9C10

3”

Tighten screws.	Run the power supply wire through the strain relief, leaving
	3” between the end of the wire and the strain relief. Tighten
	the strain relief around the wire.

C11

C12

	Install the wiring and the strain relief into the wiring access			Connect 6” duct and vent to the outside. Use duct tape to
	hole you made earlier.			secure joints. If ducting does not fit securely, an adapter
				may need to be purchased.
	43045-	11		may need to be purchased.
		11
		01	10/15/2009

Image 11

Contents 43045-01 110/15/2009 43045-01 210/15/2009 R n i n g43045-01 310/15/2009 43045-01 410/15/2009 Before Installation43045-01 510/15/2009 43045 10/15/2009 Section a New Construction attaching to joist43045-01 710/15/2009 Section B New Construction suspended between joists16 bit 43045 01 10/15/200943045-01 Section C Existing Construction accessible from aboveB10 B11 910/15/200943045-01 10/15/2009 C5C6C12 C9C10D1 D2 Section D Existing Construction accessible from below43045-01 10/15/2009 Section E Final Installation 43045-01 10/15/2009 E12 Trouble Shooting Preventative MaintenanceMaintenance Limited Warranty Trouble Shooting Warranty