Hunter Fan 82043 manual Section a New Construction attaching to joist, 43045 10/15/2009

Page 6

Section A - New Construction - attaching to joist

A1

OR

Pop out a wiring access slug.

	A2
	5/8	5/8
	5/8	1/2
	1/2	1/2
	1/2

A3

Position the correct depth mark at the bottom edge of the joist based upon the the thickness of your sheetrock.

Drive mounting screws (supplied) into joist or framing.

A4

3”

A5

Run the power supply wire through the strain relief, leaving			Install the wiring and the strain relief into the wiring access
3” between the end of the wire and the strain relief. Tighten			hole you made earlier.
the strain relief around the wire.
		6
43045-
	01	10/15/2009

Image 6

Contents 43045-01 110/15/2009 R n i n g 43045-01 210/15/200943045-01 310/15/2009 Before Installation 43045-01 410/15/200943045-01 510/15/2009 Section a New Construction attaching to joist 43045 10/15/2009Section B New Construction suspended between joists 43045-01 710/15/200943045 01 10/15/2009 16 bit910/15/2009 Section C Existing Construction accessible from aboveB10 B11 43045-01C5C6 43045-01 10/15/2009C9C10 C12Section D Existing Construction accessible from below D1 D243045-01 10/15/2009 Section E Final Installation 43045-01 10/15/2009 E12 Preventative Maintenance MaintenanceTrouble Shooting Trouble Shooting Warranty Limited Warranty