Hunter Fan 82043 B10 B11, Section C Existing Construction accessible from above, 910/15/2009

Page 9

B10

B11

Install the wiring and the strain relief into the wiring access	Connect 6” duct and vent to the outside. Use duct tape to
hole you made earlier.	secure joints. If ducting does not fit securely, an adapter
	may need to be purchased.

Vaya a la sección E – Instalación Final en la página 14.

Section C - Existing Construction – accessible from above

C1
11”	9	⁄”	OR
		⁄”

NO EXISTING FAN

Remove an existing fan and check to make sure the opening
is large enough to accommodate the new fan housing. The
opening needs to be 11” x 9 5/8”.	910/15/2009
43045-01	910/15/2009

Image 9

Contents 43045-01 110/15/2009 43045-01 210/15/2009 R n i n g43045-01 310/15/2009 43045-01 410/15/2009 Before Installation43045-01 510/15/2009 43045 10/15/2009 Section a New Construction attaching to joist43045-01 710/15/2009 Section B New Construction suspended between joists16 bit 43045 01 10/15/2009B10 B11 Section C Existing Construction accessible from above910/15/2009 43045-0143045-01 10/15/2009 C5C6C12 C9C10D1 D2 Section D Existing Construction accessible from below43045-01 10/15/2009 Section E Final Installation 43045-01 10/15/2009 E12 Preventative Maintenance MaintenanceTrouble Shooting Limited Warranty Trouble Shooting Warranty