Hunter Fan 43045, 82043 manual D1 D2, Section D Existing Construction accessible from below

Page 12

Vaya a la sección E – Instalación Final en la página 14.

Section D - Existing Construction – accessible from below

D1 D2

Remove one of the wiring access slugs on the top of the housing. Use a second wiring access plug if needed.

Remove the mounting rail brackets.

D3

EXISTING FAN

D4

3”

Remove an existing fan and check to make sure the opening

 

Run the power supply wire through the strain relief, leaving 3”

is large enough to accommodate the new fan housing. If

 

between the end of the wire and the strain relief. Tighten the

there is no existing fan choose an appropriate location to

 

strain relief around the wire.

make an 11” x 9 5/8” opening.

12

 

43045-

 

 

01 10/15/2009

Image 12
Contents 43045-01 110/15/2009 R n i n g 43045-01 210/15/200943045-01 310/15/2009 Before Installation 43045-01 410/15/200943045-01 510/15/2009 Section a New Construction attaching to joist 43045 10/15/2009Section B New Construction suspended between joists 43045-01 710/15/200943045 01 10/15/2009 16 bitSection C Existing Construction accessible from above B10 B11910/15/2009 43045-01C5C6 43045-01 10/15/2009C9C10 C12Section D Existing Construction accessible from below D1 D243045-01 10/15/2009 Section E Final Installation 43045-01 10/15/2009 E12 Preventative Maintenance MaintenanceTrouble Shooting Trouble Shooting Warranty Limited Warranty