Hunter Fan 82043 manual 43045 01 10/15/2009, 16 bit

Page 8


B4				B5	1/16” bit
B4				B5	1/16” bit

Mark position of screws by using holes as a template.

Drill a pilot hole at the TOP of each outline.

B6

Insert mounting screws, leaving space between the screw

head and the joist. (Screws are supplied.)

B8

B7

Attach the rails onto the screws.

B9

3”

Tighten screws.			Run the power supply wire through the strain relief, leaving
			3” between the end of the wire and the strain relief. Tighten
			the strain relief around the wire.
	43045-	8
	43045-	01 10/15/2009

Image 8

Contents 43045-01 110/15/2009 R n i n g 43045-01 210/15/200943045-01 310/15/2009 Before Installation 43045-01 410/15/200943045-01 510/15/2009 Section a New Construction attaching to joist 43045 10/15/2009Section B New Construction suspended between joists 43045-01 710/15/200943045 01 10/15/2009 16 bitSection C Existing Construction accessible from above B10 B11910/15/2009 43045-01C5C6 43045-01 10/15/2009C9C10 C12Section D Existing Construction accessible from below D1 D243045-01 10/15/2009 Section E Final Installation 43045-01 10/15/2009 E12 Trouble Shooting Preventative MaintenanceMaintenance Trouble Shooting Warranty Limited Warranty