ABOUT SPEAKER CABLE
PRECAUTION: Before proceeding, read and follow the safety precautions below.
Before running speaker cable through walls, under walkways, patios, etc., check local building code requirements or contact a qualified installer (see dealer).
Before digging, verify location of gas lines and buried cables with local utility companies.
Information on running speaker cable through walls, under walkways, patios, etc. is not provided in this manual. If you are not comfortable with this type of installation, contact a qualified installer (see dealer).
Preparing the Cable
Always use
1.Measure and mark the path from amplifier to speaker(s) and/or speaker to speaker to determine length of cable required.
2.Add 2´ to 3´ feet extra to allow some play when installing.
3.Select correct gauge using the chart below.
4.If cable is to run underground it must be rated for direct burial and/or enclosed in PVC pipe to prevent deterioration over time. Contact a qualified installer before commencing installation in this case (see dealer).
5.Cut cable to required length.
6.Using wire strippers, strip the outer casing of the cable back about 2˝ at either end.
7.Strip inner insulation on both wires back about 1/2˝ at either end.
The following chart identifies the minimum gauge requirements for various cable lengths:
MINIMUM GAUGE REQUIREMENTS
LENGTH | DIAMETER | GAUGE |
Under 4.5 m (15 feet) | 1.3 mm (0.05 in) | 16 awg |
|
|
|
Under 9 m (30 feet) | 1.6 mm (0.06 in) | 14 awg |
|
|
|
Over 9 m (30 feet) | 2.0 mm (0.08 in) | 12 awg |
4