Connecting HDMI/DVI to a TV

•Press the P.SCAN button on the front panel while unit in stop mode, Video resolution will switch between 576i and 576p.

•Make sure that the colour coded connections match. That is, the Y, PB and PR component output jacks of your DVD Recorder & VCR should be connected to the exact corresponding component input jacks on your TV. Otherwise, red or blue images will be displayed on the TV screen.

•Consumers should note that not all high definition television sets are fully compatible with this product and may cause artifacts to be displayed in the picture. In case of progressive scan picture problems, it is recommended that you switch the connection to the standard definition output.

If there are questions regarding your Samsung TV set’s compatibility with this DVD Recorder & VCR, please contact our customer service centre.

What is “Progressive Scan”?

Progressive scan has twice as many scanning

Note lines as the interlace output method has. Progressive scanning method can provide better and clearer picture quality.

Depending on your TV, the method of connec- tion may differ from the illustration above.

See your TV User’s Manual to find out if your TV supports Progressive Scan. If Progressive Scan is supported, follow the TV User’s instructions regarding Progressive Scan settings in the TV’s menu system.

You must connect the DVD Recorder & VCR to the component(s) before using the Progressive Scan feature.

Do not press the P.SCAN button if you are using a TV that does not support Progressive mode. Nothing will be displayed on the screen if pressed.

To release the Progressive mode, press the P.SCAN button on the front panel once or twice times.

The screen will recover after the PSO LED on the front panel display turns off.

The Component jacks will not output video resolutions above 576p.

To view 720p and 1080i, connect the DVD Recorder & VCR to your TV with the supplied HDMI cable.

With HDMI connected, press the P.SCAN button to alternate between all available resolutions. (See pages 31~32)

If your TV has a HDMI/DVI input, connect HDMI/DVI cable to a TV. You will enjoy the best quality images and sounds.

❚Case 1 : Connecting to a TV with HDMI Jack

•Using the HDMI cable connect the HDMI OUT jack on the rear of the DVD Recorder & VCR to the HDMI IN jack of your TV.

•Press the input selector on your TV remote control until the HDMI signal from the DVD Recorder & VCR appears on your TV screen.

❚Case 2 : Connecting to a TV with DVI Jack

•Using the DVI Adapter Cable, connect the HDMI OUT jack on the rear of the DVD Recorder & VCR to the DVI IN jack of your TV.

•Using the audio cables, connect the AUDIO (red and white) OUT jacks on the rear of the DVD Recorder & VCR to the AUDIO (red and white) IN jacks of your TV. Turn on the DVD Recorder & VCR and TV.

•Press the input selector on your TV remote control until the DVI signal from the DVD Recorder & VCR appears on your TV screen.

To watch through the HDMI output, set the

CAUTION digital audio output to PCM. (See page 30) Depending on the HDMI device (TV/HDMI

Receiver) you use, audio may not be supported. If TV does not support Dolby digital/DTS, Audio output is not available when you set Digital output as Bitstream or select DTS On in Audio setup menu. In this case, set the digital audio output to PCM or DTS off.

Connections

English - 19