Samsung DVD-VR325P manual Setting Up the Audio Options, Digital Output, Dynamic Compression

Setting Up the Audio Options

Allows you to setup the audio device and sound status settings depending on the audio system in use.

With the unit in Stop mode/No Disc mode, press
1 the MENU button.
Press the …† buttons to select Setup, then press
2 the OK or √ button.
No Disc	Setup
Programme

❚Digital Output

•PCM : Converts to PCM (2CH) 48kHz audio. Select PCM when using the Analog Audio Outputs.

•Bitstream : Converts to Dolby Digital Bitstream (5.1CH). Select Bitstream when using the Digital Audio Output.

	Be sure to select the correct Digital Output or
Note	no audio will be heard.

❚DTS

•Off : Doesn’t output digital signal.

•On : Outputs DTS Bitstream via digital output only. Select DTS when connecting to a DTS Decoder.

Setup

System	√
Setup Clock Set	√
Install	√
Language	√
Audio	√

Note

When DTS soundtrack is played, sound is not output from Analog Audio Output.

System

	Video		√
	Parental Control		√
MOVE	OK	RETURN	EXIT

Press the …† buttons to select Audio, then press
3 the OK or √ button.
Audio setup menu will be displayed.
	No Disc			Audio
	Programme	Digital Output	: PCM	√
		DTS	: Off
	Setup			√
		Dynamic Compression : On		√
	MOVE	OK	RETURN	EXIT

4 Press the …† buttons to select the desired audio option, then press the OK or √ button.

5 Press the …† buttons to select the desired item, then press the OK or √ button.

■ Press the RETURN or œ button to return to the

Note previous menu. Press the MENU button to exit the menu.

❚Dynamic Compression

This is only active when a Dolby Digital signal is detected.

•On : When Movie soundtracks are played at low volume or from smaller speakers, the system can apply appropriate compression to make low-level content more intelligible and prevent dramatic passages from getting too loud.

•Off : You can enjoy the movie with the standard Dynamic Range.

30 - English