Samsung DVD-VR325/XEF If the timer settings overlap, To exit without saving the current setting

6 Fill in the items using the …†œ √ buttons. œ √ : Moves to the previous/next item, …† : Sets a value.

• To : Select the media to record DVD or VCR.

• PR : The video input source (AV1, AV2 or AUX), or the broadcasting channel you want to make a timer recording from.

• Day : Set the recording day.

Daily, MO-SA, MO-FR, W-SA, ...W-SU, MON01, ...WED31

• Start/End Time : Start and end time of the timer recording.

●Recording Speed (DVD)

AUTO : Select when you want to set video quality automatically. In AUTO Mode, the most suitable record mode is adjusted automatically, according to remaining time on the disc and length of the timer recording. This function is selected only one mode in XP, SP, LP and EP modes and you can use this mode for timer recording.

XP (high quality) : Select when audio and video qualities are important. (Approx. 1 hour)

SP (standard quality) : Select to record in standard quality. (Approx. 2 hours)

LP (low quality) : Select when a long recording time is required. (Approx. 4 hours)

EP (extended mode) : Select when a longer record- ing time is required. (Approx.6 hours at 1.2Mbps or Approx. 8 hours at 0.8 Mbps.)

●Recording Speed (VCR)

AUTO : Select when you want to set video quality automatically. It depends on remaining time of VCR tape.

SP : Standard Play, for best picture quality.

LP : Long Play, for maximum recording time (3 times SP).

●V/P (VPS/PDC)

VPS : Video Programme System

PDC : Programme Delivery Control

•Do not select V/P unless you are sure the programme you wish to record is broadcast with VPS/PDC. If you do set V/P to On, then you must set up the start-time EXACTLY according to the published TV schedule.

Otherwise the timer recording will not operate.

When you are recording at EP mode on a

Note DVD-RW(V mode)/-R disc, it may not record the full 6 or 8 hours because the unit uses the VBR

(Variable Bit Rate) ENCODING system.

For example, if you record a programme with a lot of action, it uses a higher bit rate which in turn consumes more disc memory.

7 Press the OK button.

If the timer settings overlap

The programmes are recorded in order of priority. If timer recording is set for the first programme and then again for the second programme and both programmes overlap, the following message will appear on the screen: “This setting is identical with 1” The message shows that the first programme has priority. After recording of the first programme is complete, the second programme starts being recorded.

To exit without saving the current setting

Press the MENU or RETURN button.

To return to the previous menu

Press the RETURN button if you don’t want to set a timer recording.

8 Turn the power off to finish the timer recording.

• will blink if disc or tape is not inserted.

• will appear on the front panel. It means that a timer recording is registered.

	The timer recording time may differ from the
	set time depending on disc status and overall
Note
	timer recording status (for example, recording
	times overlapping, or when the previous
	recording ends within 3 minutes before the
	start time of the next recording.)
	The numbers next to each TV programme
	listing are ShowView code numbers, which	Recording
	allow you to programme your DVD Recorder &
	ShowView is a trademark of Gemstar
	VCR instantly with the remote control. Tap in

the ShowView code for the programme you wish to record.

Development Corporation. The ShowView system is manufactured under licence from Gemstar Development Corporation.

English - 61