3HDD Addition
Caution
[Checking HDD Data]
Please, pay attention to Following information to minimize the chance of losing HDD data.
-Remember that you should protect HDD from any impact or misuse as this may cause damaged.
-The Manufacturer is not responsible for missing data or defects caused by the user’s mishandling.
Note: Adding Extra HDD. Check in advance that the HDD is compatible with the manufacturer’s DVR.
Examples that can cause loss of data or damage HDD.
-Any outside Impact on the case which could happen whilst disassembling or setting up the DVR.
-Power cut or incorrect shutdown whilst the DVR is operating.
-Refer to page
-Moving or causing any impact on the DVR during operation. Please, back up events as soon as possible to minimize disappointment should HDD data be lost.
SHR-2160/2080 HDD
The user can add up to 3 HDDs to this product. However, there are many factors that can cause electrical shock, accidents, and malfunctioning of the device inside of the product. When the user does not correctly install or apply the proper settings, the device may not recognize the HDD or the device will not run. Therefore, before adding any HDDs, it is recommended that the user contacts a specialist where you purchased the product.
[Things to consider when adding an HDD]
■When adding HDDs, pay attention so that the cable doesn’t get caught between unsuitable places or the cable’s insulation doesn’t come off.
(This may cause a malfunction or fire.)
■When adding HDDs, be careful not to receive any injury from the pointed edges inside the product.
■Pay attention so as not to lose the disassembly screws or accessories. If the screws or accessories are not put together, the product will either malfunction or won’t be able to operate.
■Check the compatibility list of HDDs before installing additional HDDs. The list of the compatible devices with Samsung DVR can be obtained from your vendor.
■If you contact the RTC battery while adding hard disks, the battery failure may happen. In this case, you will encounter failures when setting the time and operating DVR.
■If you don’t connect fan power cables after adding hard disks, the fan failure message appears on the screen. This can cause operation failures because it raises the temperature inside your DVR.
English