DIGITAL VIDEO RECORDER
GB |
| GB |
|
1Booting the System
Power On |
| |
There is a power switch on the upper right hand side behind the system. Pull the power | Recognizing incoming video signal | |
switch up to boot the system. Then, the LED on front of the system is turned on, a blue | ||
| ||
screen with the following message will appear and the system is booted. | ||
| is NTSC or PAL signal upon booting the system. | |
HDD DETECTED => 1 OK | When you turn the system on, it will recognize if the image signal is NTSC or PAL automatically to | |
set itself to the signal. | ||
HDD DETECTED => 2 NOT EXIST | ||
LOAD BOOT INFO... | If the system power is turned on without connecting video signals to the input port, the | |
LOAD CONFIGURATION... | system remembers the last signal and the system is configured accordingly. For example, if the past | |
SCSI DETECTION... | ||
| video signal connected to the input port was an NTSC signal, the system is configured to fit NTSC | |
| signals and for PAL, the same process is applied to fit PAL signals. However, if suddenly a type of | |
| video signal that is different from the video signal currently connected to the input port is connected, | |
| the screen will malfunction. In short, this is a case where PAL signal is connected to a system | |
| configured to satisfy NTSC signals or the other way around. In these cases, system power should be | |
When you turn the system on, a blue screen appears and starts searching HDD. The message | turned off, the new signal connected and then the system turned back on in order to be configured to | |
recognize the new signal. | ||
in the screen tells any HDD exists in the main body. The main body can contain 2 HDDs, | ||
If you power on the system without attaching the hard disk drive, you will get an error message | ||
one is installed properly but the other is not yet installed. | ||
indicating that no hard disk drive was found. | ||
If the second HDD is installed, the message, ‘HDD DETECTED =>2 OK’ will be displayed. | ||
|
When booting is finished, the following Live screen will appear.
HDD DETECTED => 1 NOT EXIST
HDD DETECTED => 2 NOT EXIST
1 |
| |
| ||
|
|
|
Caution
Searching the installed SCSI HDD is allowed in the booting process only. In short, the system is not able to recognize the SCSI while the system remains on though you install the SCSI cable to the set. Please be sure to turn off the system before you install the SCSI HDD.