Connecting the AM(MW/LW) Aerial | Connecting the FM Aerial |
The AM aerial (for long and medium waves) can be:
Placed on a stable surface
Fixed to the wall (you must first remove the base)
The AM(MW) aerial connector terminals are located on the rear of the system and are marked AM.
To avoid noise interference, check that the loudspeaker wires do not run close to the aerial wires.
Always keep them at least 2 inches (5 cm) away.
|
| ANTENNA |
|
| AM |
DC JACK | ||
|
| FM (75Ω ) |
DC | IN | 12V |
How to connect a COAXIAL TYPE aerial.
Connect a 75Ω antenna to the FM aerial terminal. | GB |
| |
Plug the connector on the FM aerial supplied into the coaxial socket |
|
(75Ω ) marked FM on the rear of the system. |
|
Follow the instructions given on Page 8 to tune into a radio station, |
|
and determine the best position for the aerial. |
|
If reception is poor, you may need to install an outdoor aerial. |
|
To do so, connect an outdoor FM aerial to the FM socket on the rear |
|
of the system, using a 75Ω coaxial cable (not supplied). |
|
FMFM
FM AERIAL | 75Ω COAXIAL CABLE |
(supplied) | (not supplied) |
5