Samsung SCC-B2007P manual Risk of Electric Shock do not Open, COVER. no User

Page 2

E

CAUTION

RISK OF ELECTRIC

SHOCK DO NOT OPEN

CAUTION

: TO REDUCE THE

RISK OF

ELECTRIC SHOCK,

DO NOT REMOVE REAR

COVER. NO USER

SERVICEABLE PARTS INSIDE.

REFER TO

QUALIFIED

SERVICE

PERSONNEL.

This symbol indicates

high voltage is present inside. It is dangerous to make any kind of contact with any inside part of this product.

This symbol alerts you that important literature concerning operation and maintenance has been included with this

product.

Important Safety Instructions

1.Read these instructions.

2.Keep these instructions.

3. Heed all warnings.

E

4.

Follow all instructions.

5.

Do not use this apparatus near water.

6.

Clean only with dry cloth.

7.

Do not block any ventilation openings. Install in accordance

 

with the manufacturer’s instructions.

8.

Do not install near any heat sources such as radiators, heat

 

registers, or other apparatus (including amplifiers) that produce

 

heat.

9.

Do not defeat the safety purpose of the polarized or grounding-

 

type plug. A polarized plug has two blades with one wider than

 

the other. A grounding type plug has two blades and a third

 

grounding prong. The wide blade or the third prong are

 

provided for your safety. If the provided plug does not fit into

 

your outlet, consult an electrician for replacement of the

 

obsolete outlet.

To prevent damage which may result in fire or electric shock hazard, do not expose this appliance to rain or moisture.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions.

1)This device may not cause harmful interference, and

2)This device must accept any interference that may cause undesired operation.

CAUTION:

Danger of explosion if battery is incorrectly replaced.

Replace only with the same or equivalent type recommended by the manufacturer.

Dispose of used batteries according to the manufacturer’s instructions.

10.

Protect the power cord from being from being walked on or

 

pinched particularly at plugs, convenience receptacles, and the

 

point where they exit from the apparatus.

11. Only use attachments/accessories specified by the

 

manufacturer.

12.

Use only with cart, stand, tripod, bracket, or table specified by

 

the manufacturer, or sold with the apparatus. When a used,

 

caution when moving the cart/apparatus combination to avoid

 

injury from tip-over.

13.

Unplug this apparatus. When a cart is used, use caution when

 

moving the cart/apparatus combination to avoid injury from tip-

 

over.

14.

Refer all servicing to qualified service personnel. Servicing is

 

required when the apparatus has been damaged in any way,

 

such as power-supply cord or plug is damaged, liquid has been

 

spilled or objects have fallen into the apparatus, the apparatus

 

has been exposed to rain or moisture, does not operate

 

normally, or been dropped.

2

3

Page 1 Page 3
Image 2
Page 1 Page 3
Contents SCC-B2303P/B2003PD SCC-B2307P/B2007PF Risk of Electric Shock do not Open COVER. no UserContents IntroductionSpecial Features Part Names and Functions Side ViewRear View Usual operation mode ➃ DAY/NIGHT External Signal Input & Alarm Signal Output⑤ Camera Operation SwitchSetup Switch Setup menu modeChecking the contents of the package InstallationBefore Installation What should be done during installation and useLens Fixing InstallationConnecting Auto Iris Lens Connector Lenses without zoom function Setting Switch ControlBack Focus Adjustment Lenses with zoom functionConnecting Cables and Checking Operation Camera ID Located at any place as desired by using the submenuCamera Set-Up Camera ID❿ ELC Iris❿ ALC BLC BLC❿ User Area Size❿ BW COLOR/BW❿ Color ❿ Auto ❿ EXT❿ AGC ShutterAGC/MOTION ❿ ATW White BAL❿ Motion ❿ AWCNot use Sync function SyncSpecial Submenu screen will appear❿MOTION DET ❿ Mirror Horizontally flips the video signal❿ Detail Adjusts the horizontal and vertical sharpness Motion DET detects any movement of objects. if you activateExit Product Specification❿ Preset ❿ QuitSCC-B2303P/B2003P/B2307P/B2007P Special Features F1.2 0.001 LuxDescription SCC-B2303P/B2003PD SCC-B2307P/B2007P BedienungsanleitungSicherheitshinweise Beilage Kapitel 1 ÜbersichtKapitel TAG/NACHTKapitel 2 Speziale Merkmale ➁ Video Ausgabe Terminal ALC Objektiv Auswahlschalter① Strom Anzeiger LED ➂ Fernbedienung Input Terminal RS-232Der üblichen Betriebsmode TAG/NACHT GND Alarm OUTDer Setup Menu Mode ➅ Strom Anschluß TerminalÜberprüfung des Inhalts in der Verpackung Kapitel 4 InstallationVor der Installation Manuale PassepartoutCS Objektive Fall Einstellung des ObjektivsDamp Strom +12V Damp+ CS Objektive Objektive FallObjektive mit Zoom Funktion Einstellung des AuswahlschaltersEinstellung des Rück-brennpunktes Back Focus Objektive ohne Zoom FunktionAnschluß der Kabel und Überprüfung des Betriebs BNC Kabel Video AUS TerminalAktivitaet EIN Kapitel 5 Aufbau der KameraKamera ID Kamera IDRUE BlendeDC Blende Objektiv Ausgang Verl❿ Benutzer Bereich Groesse❿ S/W FARBE/S/W❿ Farbe Extern S/W Auto S/WPegel Weissabgl ATWAGC/BEWEGUNG Auto❿ ATW Weissabgl❿ Bewegung BewegungBis +138HPAL SpezialRechts Linie Lock❿AKTIVITAET ❿ Sichern Produkt Spezifikationen❿ Verl AUS/AUTO 2x ~ 128x/ Fest 2x ~128xFarbe 0.3 Lux F1.2 0.002 Lux 0.06 Lux F1.2 0.0004 Lux Prodotto SpecificazioneEmpfindlichkeit Farbe 0.2 Lux F1.2 0.001 Lux 0.03 Lux F1.2 0.0002 LuxArtikel Beschreibung TAG/NACHT AUS/EINEinstellung vonBEREICH/EMPFINDLICHKEIT SCC-B2303P/B2003P SCC-B2307P/B2007PF Installez le produit dans une aire bien ventilée Précautions de sécuritéFonction JOUR/NUIT SommaireChapitre 1 Introduction Chapitre 2 Caractéristiques Vue de côtéVue arrière Mode Setup ⑤ Bouton de réglage de la caméra SetupMode standard ➅ Port d’alimentation secteurPrécaution d’installation et d’utilisation Chapitre 4 InstallationAvant l’installation Manuel d’utilisation Adaptateur ‘C Mount’ Connecteur de’objectif CS Lors de l’objectif C Fixation de l’objectifLors de l’objectif CS ’objectif CObjectif avec fonction de zoom FocalisationRéglage du bouton de sélection de l’objectif Objectif sans fonction de zoomConnexion du câble & Vérification du fonctionnement Manu UtilAuto Niveau Avec l’objectif DC IrisDC Iris Taille Cjour❿ Util Zone ❿ Couleur COULEUR/N&B❿ N&B… PorteuseNiveau Auto N&BDuree External N&B❿ CAG CAG/MOUVEMENTFIXEX6 → FIXEX8 → FIXEX12 CAG❿ Mouvement PresetBAL Blancs ❿ BABleu PhaseRouge Pour accéder au sous-menuDET Mouve ❿DET MouveRéglez la sensibilité de détection en utilisant Zone❿ Quitter Spécifications TechniquesSortie ❿ SauverLux F1.2 0.002 Lux Noir et blanc Lux F1.2 0.0004 Lux Lux F1.2 0.001 Lux Noir et blanc Lux F1.2 0.0002 LuxJOUR/NUIT SCC-B2303P/B2003P SCC-B2307P/B2007P Medidas de seguridad Capítulo ContenidoCapítulo 1 Introducción ApéndiceCapítulo 2 Características Especiales Vista LateralVista Posterior Presionelo durante cerca de 2 segundos En el modo del menú de la configuraciónEn el modo general de la operación ➅ Puerto de la Conexión de alimentaciónEs Comprobación del contenido del paquete Capítulo 4 InstalaciónAntes de la Instalación Qué se debe hacer durante la instalación y el usoEn caso de las lentes de CS InstalaciónFijación de la Lente Lentes de CS En caso de las lentes de CLentes sin la Función de Zoom Fijar Control del ConmutadorAjuste de Foco Trasero Lentes con la Función de ZoomTerminal de entrada de video Conectar Cables y Comprobar la OperaciónSalida de video Manu Línea Capítulo 5 Configurar la CámaraCámara ID DET Movi onDiafragma DiafragmaVUE DC Diafragma❿ Util Zona DimensionCluz CluzGanancia COLOR/ByN❿ ByN CAG ColorEn este menú Nivel❿ Salida Auto Obturador→ AUTOX6 ObturadorCAG/MOVIMIENTO Rápido BAL Blanco❿ Movimiento ❿ BMRojo Es SyncEspecial Azul RET VUE❿DET Movi La señal de Alarm❿ Detalle Ajusta la nitidez horizontal y vertical Salida Graba todos los cambios al menú hasta ahoraEspecificación de Producto ❿ DejarArtículo Descripción Color 0.3 Lux F1.2 0.002 LuxF1.2 0.0002 Lux Artículo Descripción DÍA/NOCHE Manuale d’Utente Avvertenza AttenzioneCapitolo ContenutiCapitolo 1 Introduzione AppendiceCapitolo 2 Caratteri Speciali Vista FiancoBar Controllo Fuoco Retro Interrutore Setting Lente ALCCavo Controllo Lente Otturatore Automatica ① LED Display Potenza➅ Porto Collrgamento PotenzaAdattatore ⑤ Interruttore Operazione Camera Interruttore SetupNel modo menu di setup Questo porto è collegato al cavo della potenzaadattatoreControllazione Gli Contenuti del Pacco Capitolo InstallazionePrima Installazione Collegamento Lente Otturatore Automatico Collegatore InstallazioneFissaggio Lente Lenti con funzione zoom Controllo Interruttore montaggioAggiustamento Fuoco Retro Lenti senza funzione zoomCollegamento cavi e controllazione operazione Movimento DET on Capitolo 5 Set-up CameraID Camera ID CameraMettere il livello da premendo la chiave Left o Right Lente DC IrisDC Iris Uscita Esci Basso DimensioneID Camera OFF Iris Colore Shutter Auto❿ B/N Colore / B/N❿ Colore Livello Auto B/NDurata ❿ ESTFisso AGC/MOVIMENTO→ Fisso Voi al modo Lento e il modo Veloc rispettabilità BIL Bianco❿ Movimento MovimentoVelocitá SpecialeRosso RET BLU SpecialePer ❿ACTIVITY DETActivity DET Sensibilita RETRisparmiare tutti cambiamenti al menu fino d’ora Uscita❿ Esci 0.06 Lux F1.2 0.0004 LuxArticolo Colore 0.3 Lux F1.2 0.002 Lux 0.06 Lux F1.2 0.0004 LuxColore 0.2 Lux F1.2 0.001 Lux 0.03 Lux F1.2 0.0002 Lux Part No AB68-00424A02 Made in Korea
Related manuals
Manual 110 pages 3.52 Kb Manual 1 pages 28.42 Kb
Top Page Image Contents