Samsung AQ12TSBNCEE, AQ24TSBXEUR, AQ18TSBN, AQ12UGFN, AQ24TSBN manual Correct Inclined, Cracked, Ditch

Cutting or extending the pipe

5. Check if you flared the pipe correctly (see examples of incorrectly flared pipes below).

Correct	Inclined	Damaged	Cracked	Uneven
		Surface		Thickness

6.Align the pipes to connect them easily. Tighten the flare nuts first with your hands, and then with a torque wrench, applying the following torque:

Flare nut

Indoor outlet	pipe
		Connecting pipe

Outer Diameter		Torque
	N•m		kgf•cm
ø6.35 mm	14~18		140~180
ø9.52 mm	34~42		350~430
ø12.70 mm	49~61		500~620
ø15.88 mm	68~82		690~830

• Excessive torque can be cause of gas leakage. In case brazing the pipe, the nitrogen gas must be blown into the

pipe (50 Pa). The joint must be accessible and serviceable.

7. For further details on how to connect to the outdoor unit and purge the air, refer to page 34~36.

• Tighten the flare nut with torque wrench according to specified method.

If the flare nut is over-tightened, the flare may break and cause refrigerant gas leakage.

Installing and connecting the drain hose of the indoor unit

When installing the drain hose for the indoor unit, check if condensation draining is adequate. When passing the drain hose through the 65-mm hole drilled in the wall, check the followings:

Wall

Indoor unit

Drain hose

The drain hose must not be bent.

The drain hose must NOT slant upwards.

5cm

less

Keep a clearance of at least 5cm between the end of the drain hose and the ground.

The end of the drain hose must NOT be placed under water.

Ditch

Do not place the end of the drain hose in a hollow.

32

Boracay EUR_AQ09T&U@_IBIM_32447A_EN-4.indd 32

2015/7/7 14:56:39