Samsung HT-J5550W/EN Installing the Speakers on the Tallboy Stand, Speaker Cable Connections

Connections

Installing the Speakers on the Tallboy Stand

* HT-J5550W only

1.	Turn the Stand Base upside-down and connect	1 Stand	Base	2
2.	it to the Stand.
	Use the driver to fasten the screws (5x20) on
	the 4 marked holes.

3.Straighten the provided speaker cable and run it through the centre hole of the Stand Base.

Pull the cable out from the hole of the stand pole.

4.Connect the upper Speaker to the assembled Stand.

Stand

3

4

Speaker

Stand

5. Insert a screw (5x15) and fasten it clockwise	5
through the hole on the rear of the speaker

using a screwdriver.

6.Arrange the speaker cable along the groove on the rear side of the stand pole.

7. Connect the arranged speaker cables to the	7
port on the speaker’s rear side while matching

their colours.

8.This is the appearance after the speaker is installed.

Follow this steps to install other speaker.

Speaker Cable Connections

6

8

Or

1.Match each speaker cable bundle to the correct speaker by matching the coloured band on each bundle to the coloured sticker on the bottom or back of each speaker.

2.Connect the speaker wire plugs from each speaker to the back of the product by matching the coloured band on each cable to the colours of the speaker jacks. When connecting, make sure to match label colour on the back of speaker.

10 - English