Samsung HT-J5550W/EN manual Network Setup, Configuring Your Network Connection, Wired Network

Settings

-When pressing the buttons on the primary remote control, make sure that you have selected the FM station using the primary remote control.

+

RDS DISPLAY		TA
1	2	3
PTY -	PTY SEARCH	PTY +
4	5	6

1.Press the PTY SEARCH button while listening to an FM station.

2.Press the PTY- or PTY+ button until the PTY code you want appears on the display.

~The display gives you the PTY codes described to the right.

3.Press the PTY SEARCH button again, while the PTY code selected in the previous step is still on the display.

~The centre unit searches 15 preset FM stations, stops when it finds the one you have selected, and tunes in that station.

Network Setup

When you connect this product to a network, you can use network based applications and functions such as BD-LIVE and upgrade the product's software through the network connection.

Configuring Your Network Connection

To begin configuring your network connection, follow these steps:

1.In the Home screen, select Settings, and then press the E button.

2.Select Network, and then press the E button.

3.Select Network Settings, and then press the E button.

4.Go to the instructions for Wired networks starting below or the instructions for Wireless networks. (See page 23)

Wired Network

Wired – Automatic

After following Steps 1 to 3 above:

1.In the Network Settings screen, change Network Type to Wired. Then, select Connect and press the E button. The product detects the wired connection, verifies the network connection, and then connects to the network.

2.When it is done, highlight OK, and then press E button.

Wired - Manual

If you have a static IP address or the automatic procedure does not work, you'll need to set the Network Settings values manually.

After following Steps 1 to 3 above:

1.In the Network Settings screen, change Network Type to Wired. Then, select Connect and press the E button.

The product searches for a network, and then displays the connection failed message.

✎If it is possible to connect the home cinema to your network wirelessly, select Change Network at this point, change the Network Type to Wireless, and then go to the instructions for wireless networks. (See page 23)

Network Settings

Wired network connection failed.

MAC Address	XX:XX:XX:XX:XX:XX
IP Address	0.	0.	0.	0
Subnet Mask	0.	0.	0.	0
Gateway	0.	0.	0.	0
DNS Server	0.	0.	0.	0

Unable to connect to the network. Try the following: check if your IP address is set correctly in IP Settings. Contact your Internet service provider for more information.

Change Network	IP Settings	Retry	Close
	a Previous	d Skip	< Move " Select

2.Use the ◄► buttons to select IP Settings, and then press the E button. The IP Settings screen appears.

3.Select the IP setting field, and then set it to Enter manually.

22 - English