Samsung SCC-C4239P, SCC-C4237P manual Focus Mode, Zoom Speed, Display Zoom, Digital Zoom, Detail

setup

FOCUS MODE

You can select a focus mode according to the angle that you adjusted for camera recording.

-AF : This will monitor the screen continuously to focus automatically. If you adjust the focus manually, that will operate the same as in <MF>. This will also restore focus after the operation of zoom.

-ONEAF : Restores focus after the operation of zoom, and operates the same as in <MF> unless the operation of zoom is executed.

-MF : You can adjust the focus manually.

DAY/NIGHT	AUTO
WHITE BAL
FOCUS MODE		ONEAF
ZOOM SPEED	[2]
DISPLAY ZOOM			OFF
DIGITAL ZOOM			X16
DETAIL	[2]
V-SYNC			INT
AGC COLOR SUP			MID

M While you are working on the following objects, <AF> may not work properly. If this is the case, use <MF> instead.

-Very bright object, or dominant object in a dark scene

-Object against the rear side of a moist or dirty glass

-A scene where nearby and distant objects co-exist

-White wall or single-colored object

-Venetian blinds and other horizontally striped objects

ZOOM SPEED

You can adjust the zoom operation speed.

DISPLAY ZOOM

You can set to display the zoom status on the screen.

It will disappear in about 3 seconds if the zoom factor has no further change.

DIGITAL ZOOM

You can set the maximum allowable digital zoom ratio.

Digital Zoom will start operation after it is zoomed in to the maximum optical ratio of x34. If you set DIGITAL ZOOM to x16, you can take a shot at up to x544 (34x16). When you set DISPLAY ZOOM as on, you may see zoom value on the screen.

DETAIL

Used to adjust the vertical and horizontal distinction, respectively.

24_ setup