Kohler K-10103, K-10104 manual Troubleshooting

Troubleshooting (cont.)
Symptoms	Probable			Recommended Action
	Causes
	D. There is			D. Remove the cover and check
		water			for corrosion on the
		leakage on			connections between the
		electrical			battery to solenoid and the
		components			battery holder to the sensor. If
		or			possible, clean the terminals. If
		connectors.			unable to repair the connection,
					order a new sensor assembly,
					battery holder, or solenoid
					assembly, as required. Inspect
					the gasket between the valve
					body and spout hose for cuts,
					debris, etc. If the gasket is
					damaged, order a new gasket.
					The origin of the leak must be
					investigated and repaired.
	E.	The		E.	Remove the cover and replace
		battery life			the battery. The faucet requires
		has			a standard 2CR5 6 V lithium
		expired.			battery. This item is not
					available from Kohler Co., but
					can be purchased at retail
					stores.
	F.	Sensor		F.	Wipe the sensor eyes with a
		eyes are			damp soft cloth. Wipe dry with
		dirty.			a dry soft cloth.
	G. Supply			G. Verify that the water supply is
		pressure is			turned on and that pressure is
		low.			at least 20 psi (137 kPa).
	H. Incorrect			H. Verify that the faucet is
		installation.			mounted flat to the deck
					surface and that the sensor eyes
					are aligned to the user area.
	I.	The filters	I.		Refer to the ″Service the Filters″
		are			section of the Homeowners
		plugged.			Guide.
	J.	The		J.	Remove the aerator and clean.
		aerator is			For calcium/mineral deposits,
		plugged.			soak the plastic insert in a 50:50
					mix of water and vinegar. Soak
					only the plastic insert.
	K.	Sensor		K.	Replace the sensor assembly.
		eyes are
		scratched.
Kohler Co.		11			1056542-2-B