Kohler K-10104, K-10103 manual Troubleshooting

Troubleshooting (cont.)
Symptoms		Probable		Recommended Action
		Causes
		L.	Hose is	L.	Check the hoses to make
			kinked.		certain they are not kinked. If
					a hose is kinked, disconnect the
					hose, straighten, then reconnect.
		M. The		M. Remove the valve cover and
			solenoid		solenoid. Replace the solenoid
			does not		as needed. Refer to the ″Test
			work.		and Service the Solenoid″
					section of the Homeowners
					Guide.
2.	Low flow.	A.	Supply	A.	Check filtration systems for
			pressure is		blockage. Check incoming
			low.		water pressure. Pressure should
					be at least 20 psi (137 kPa).
		B.	The filters	B.	Refer to the ″Service the Filters″
			are		section of the Homeowners
			plugged.		Guide.
		C.	The	C.	Remove the aerator and clean.
			aerator is		For calcium/mineral deposits,
			plugged.		soak the plastic insert in a 50:50
					mix of water and vinegar. Soak
					only the plastic insert.
3.	Constant	A.	The	A.	Turn off the water supply and
	water flow.		diaphragm		purge the faucet. Remove the
			seal is		cover and check the diaphragm
			dirty or		and surrounding area for
			damaged.		debris. Clean out any debris. If
					the diaphragm is damaged,
					order a replacement. Refer to
					the ″Service the Diaphragm″
					section of the Homeowners
					Guide.
		B.	The	B.	Remove the valve cover and
			battery life		replace the battery. The spout
			has		requires a standard 2CR5 6 V
			expired.		lithium battery. This item is not
					available from Kohler Co., but
					can be purchased at retail
					stores.
		C.	The	C.	Remove the valve cover and
			solenoid is		solenoid. Check the solenoid
			plugged.		holes for debris.
1056542-2-B				12	Kohler Co.