Radio Shack DX-398 owner manual Storing Sw Frequencies In Memory

Page 28

3.Repeatedly press PAGE to select the page where you want to store the frequency. 1 or 2 appears under PAGE.

Notes:

•PAGE flashes only when the receiver is set to SW mode.

•If you wait more than 10 sec- onds to press PAGE, PAGE stops flashing.

•If you pressed ATS/LW in Step 1, PAGE does not appear be- cause there is only one LW page.

4.Press M/MEM. MEMO flashes for about 12 seconds. The number for the first available empty memory location for the selected page flashes next to MEMO.

Note: If an empty memory loca- tion number does not flash, all memory locations are full in the band you selected. If this hap- pens, clear a memory location (see “Deleting a Station You Stored” on Page 30) then store the frequency. Or, to replace a stored frequency with a new fre- quency, repeatedly press TUN-

ING or to select a new frequency, press M/MEM, then press the number key for the memory location. After a few sec- onds, the receiver beeps and stores the new frequency in the memory location.

5.Press ENTER to store the fre- quency in the flashing memory location. The receiver beeps and a bracket appears around the memory location number where you stored the frequency, to show that the frequency was stored there.

STORING SW

FREQUENCIES IN

MEMORY

Follow these steps to store shortwave frequencies into empty memory loca- tions in the shortwave page.

1.Press METER/SW to select the shortwave band.

2.Tune to the frequency you want to store. The currently selected page number appears under PAGE.

3.Press M/MEM. PAGE and MEMO flash for about 10 seconds.

28

Image 28

Contents OWNER’S MANUAL with Radio Data SystemAll-BandShortwave Receiver DX-398FEATURES Control Lock — prevents accidental setting changes THE FCC WANTS YOU TO KNOW Band MetersCONTENTS Storing FM, MW, or LW Frequencies in Memory CONNECTING TO POWER Installing Internal BatteriesUsing Standard AC Power PREPARATIONUsing Vehicle Battery Power ADJUSTING THE TELESCOPING ANTENNA CONNECTING AN EXTERNAL ANTENNACONNECTING HEADPHONES CONNECTING A TAPE RECORDERTraffic Safety Listening SafelyUSING THE STAND USING THE MEMO LABEL SETTING THE MW AM TUNING INCREMENTUNDERSTANDING YOUR RECEIVER C cancel — cancels an entry AM MODE — lets you set up the alarm timerTUNING / — tunes up or down the band you selected M/MEM — stores frequencies into memoryBASIC OPERATION TURNING THE RECEIVER ON AND OFFLIGHTING THE DISPLAY LOCKING THE CONTROLSSETTING AND VIEWING THE LOCAL TIME VIEWING A WORLD TIME CHANGING A WORLD CITY NAMEManual Tuning TUNING STATIONSSelecting a Band Direct Access Tuning Scan TuningTUNING PREPROGRAMMED SHORTWAVE STATIONS PAGEDX-398SHORTWAVE PAGES CHART CountryMemory Location PageCountry Memory LocationPage StationsCountry Memory LocationPage StationADJUSTING THE TONE SPECIAL TUNING CONTROLSSTEREO/MONO-FM WIDE/NARR.-AMTUNING SSB STATIONS USING RDS5.If your time zone is using Daylight Follow these steps to use RDS1.Turn on the receiver Saving Time, repeatedly press until appearsMEMORY FUNCTIONS STORING FM, MW, OR LW FREQUENCIES IN MEMORYAutomatic Storage Manual StorageSTORING SW FREQUENCIES IN MEMORY 4.While PAGE and MEMO flash MOVING A FREQUENCY TO ANOTHER MEMORY LOCATION LOCKING/UNLOCKING A STORED STATIONDELETING A STATION YOU STORED USING PRIORITY TIMER FUNCTIONS USING THE TIMER ALARMSSetting an Alarm Silencing the AlarmTurning a Timer Alarm On or Off USING THE SLEEP TIMERTimer Recording LISTENING HINTS REFERENCE SOURCESFREQUENCY CONVERSION BAND ALLOCATIONInternational Frequencies Aircraft Frequencies Ships and Coastal Station FrequenciesTime Standard Frequencies Longwave BandLISTENING GUIDE Station LocationRemarks 5,950Station LocationRemarks 9,610Station LocationRemarks 15,084BIRDIES AMATEUR SHORTWAVE BANDS IN THE USAmateur Shortwave Bands in MHz TROUBLESHOOTING CARE AND MAINTENANCE RESETTING THE DISPLAY SPECIFICATIONS Page Limited Ninety-DayWarranty We Service What We SellRadioShack A Division of Tandy Corporation