Samsung DMB28AFS/AND manual Indicator Lights, Relating to PROGRAMMING, Display

EN 13/ IF OPERATING ABNORMALITIES OCCUR

• THE INDICATOR LIGHTS

Problem	Possible Causes	What to do?
The salt light does not go out	- No salt or an insufficient quan-	- Refill the tank and wait for the
	tity of salt in the tank to trigger	cycle to end. If you have soft
	the float.	water that requires no salt, the
		light is constantly lit.
The lights all light up one after	- Wrong programme.	- Cancel the current program-
the other		ming by holding down the Start
		button for 3 seconds and then
A light flashes and the pro-		re-programme.
	- Programme selector wrongly	- Reposition the selector on a
gramme does not start	positioned (between two not-	programme.
	ches)

• RELATING TO PROGRAMMING, DISPLAY

Problem	Possible Causes	What to do?
The cycle lasts too long	- The energy-saving program-	- Use these programmes prefe-
	mes last longer because the	rably at night when it is not so
	agitation and drying times are	important how long the pro-
	longer to compensate for the	gramme lasts or when it ends.
	lower washing and drying tem-
	peratures
The appliance trips the circuit	- Insufficient amperage to sup-	- Check the socket’s amperage
breaker	ply all the appliances being	(10A minimum) and the meter’s
	operated simultaneously.	capacity.
	- Internal fault in the appliance.	- Call a technician.
The appliance does not start	- No mains power to the socket.	- Check the socket and the fuse
	- Tap closed (Cf. table fault d01).	- Check the tap is open.
	- Water supply hose kinked.	- Check the hose line is OK.
	- Selection error or programme	- Cancel by holding down Start
	blocked.	for 3 secs and re-programme.
	- Start button pressed too long	- Just press Start briefly to start
	(greater than 2 secs).	the programme.
	- Appliance in Safety mode (anti-	- Call a technician.
	leak) (Cf. table fault d07).

24