Samsung DMB28AFS/AND manual Poor Operation, Poor Drying Results

EN 13/ IF OPERATING ABNORMALITIES OCCUR

• POOR OPERATION

	Problem	Possible Causes						What to do?
	Constant filling	- Drain hole situated too low for						- Drain wand has fallen on the
		the appliance (Cf. table fault						floor.
		d012).
	A lot of waste on the large filter	- The filters and drain outlets are						- Remove and clean the filters
	at the end of the cycle.	blocked		with	too		much	and the bottom of the drain
		residue.						outlets. Remove large residue
								from the plates before putting
								them in the machine.
	Traces of rust on stainless steel	- Quality of the stainless steel ;						- Use “special dishwasher-safe”
		not dishwasher-safe (knives in						cutlery.
		particular)						- Check that the lid on the salt con-
								tainer is closed correctly.
• POOR DRYING RESULTS
	Problem	Possible Causes						What to do?
	A lot of droplets on the glasses	- Lack or insufficient amount of						- Check the indicator light and
		rinsing product.						fill the tank completely.
		- The dose has not been distrib-						- If the tank is not empty after
		uted.						approximately 60 washings,
								call a technician.
		- Positioning of the items.						- Arrange the items to restrict
								water retention as much as
								possible. Leave the door ajar
								for a few minutes, if possible
	Droplets on plastic items, Tefal	- These items have a low calori-						- Arrange the items in the upper
	coatings, etc.	fic mass.						basket.
	Poorer drying on rapid	- On rapid programmes, the drying						- Leave the door ajar for a few
	programmes	temperature and drying period are						minutes.
		reduced to cut down the duration
		of the cycle as much as possible.
	Condensation on the wall of the	- Condensation may form on the
	inside door or the tub.	walls,	particularly			after the
		appliance		has	cooled		down
		(sound	insulation			increases
		this occurance)

27