Samsung DMB28AFS/AND manual Loading of regenerating salt Fig, Regenerating salt indicator

Page 12

EN 6/ LOADING OF REGENERATING SALT

• Loading of regenerating salt (Fig 06)

Filling with salt is essential for providing a good wash without marks. It regenerates the resins that soften the water, by removing its lime content (unless the mains water supply is soft enough). Refer to “Setting the water sof- tener”.

Important :

Only use special dishwasher regener- ating salt. Do not use table salt or any type of cooking salt, this could damage your appli- ance’s water softener.

AUnscrew and remove the stopper on the salt tank.

BFill the tank with regenerating salt special- ly designed for dishwashers.

C Use the funnel supplied with your dish- washer. The first time, top up with water up to the rim of the tank.

Regenerating salt indicator:

 

This illuminates when salt must be added.

Fig. 06

After the tank has been filled with regenerat-

 

ing salt, the indicator light may remain lit until

 

the salt has dissolved sufficiently, usually

 

after one cycle (of if the tank has not been

 

filled completely; for example, when first put-

 

ting the machine into service using the sam-

 

ple).

 

This can be deactivated as indicated in the

 

paragraph “For multi-purpose products” set-

 

ting table.

 

Important

 

If the salt overflows when filling the tank, to avoid oxidization of the tub it is advisable to remove the salt crystals or to run a Prewash programme (or Rapid programme - depending on the model).

A

Sa lt

B

r e wat

C

12

Image 12
Contents Samsung Page EN Contents Safety Instructions InstallationChildren’s safety UseEnvironmental Protection ECONOMICAL, Environmentally Friendly WashingRegenerating salt tank Waste filter Main filter Rinsing product dispenserPresentation of the Control Panel Water Hardness EN 3/ InformationHardness Table Test strip10F SoftFor Traditional Products Traditional tabletsPowders or liquids Fig 10F 10-18F 18-25F 25-40F 40-55F 55-70FLoading the multi-purpose tablet dispenser Close the dispenserRegenerating salt indicator Loading of regenerating salt FigRinsing liquid indicator light Adjustment leverAdvice Lower BasketVery important Unloading your itemsAdjusting the height of the upper basket Upper BasketCutlery Basket Cutlery basket slides to allow flexible loadingLocked programme access Door not closed properlyAnti-overflow system Anti-leak systemProgrammes Table Pre-wash Washing at 60C Rinse Hot rinse Drying By condenserLavage 55/65C Rinse Hot rinse Drying By condenser Washing at 70C Rinse Hot rinse Drying By condenserDelayed start of a B programme Cancelling a programmeImmediate start of a programme Stopping the machineCleaning the Waste Filters Re-installationIf not using your dishwasher for a prolonged period PeriodicallySummary of the Faults Before Calling for ServiceIndicator Lights Relating to PROGRAMMING, DisplayPoor Washing Results Tener is set correctly. Adjust it Cient detergent Detergent Programme temperature tooCheck the indicator light Setting Prioritizing DryingPoor Operation Poor Drying ResultsIntervention Work Original PartsDetails common to all models Tests to Standard ENFor12 saucers & 1 for 2 cups Eco4 4 4 4 EN Notes