Samsung RS21DXNA1/XET, RS21FXNA1/XET Checking the Parts, Station, Purifier Tightening band

Page 29

CHECKING THE WATER DISPENSER LINE (OPTIONAL)

1)In order to operate the ice maker properly, water pressure of 1.4 ~ 10 kgf/cm2 is required. In this range a 100 cc paper cup can be filled in 10 seconds.

2)The water filter removes particles. It does not sterilize or destroy any micro-organisms.

3)If the refrigerator is installed in an area with low water pressure (below 1.4kgf/cm2), you should install a booster pump to compensate for the low pressure.

4)Ensure the water storage tank inside the refrigerator is preperly filled initially. Push the water dis penser lever until the water runs from the outlet.

A universal water supply kit is available at extra cost from your dealer. The refrigerator manufacturer NOTE recommends using a water supply kit containing copper tubing.

Checking the Parts

Purifier

(Interior model)

Sealing tape

Clip A x 8EA

Tapping screw x 12EA

Water line

Purifier lock

station

 

Purifier

Tightening band

 

(Exterior model)

INSTALLATION INSTRUCTIONS

29

Page 28 Page 30
Image 29
Page 28 Page 30
Contents
Side by Side Safety Warnings This may cause frostbite There is a risk of electric shock or fireAny sharp edges may cause personal injury See which refrigerant is used for your refrigeratorMajor Features Setting UP the RefrigeratorBasic Model Dispenser Model Control PanelDispenser Model With CoolSelect ZoneTM Basic Model With CoolSelect ZoneTMDigital Panel Power FreezeIce Dispenser Temperature ControlWater Dispenser Cold WaterSet the locking device to the Lock Fix the water supply device tightly into the fixing holeWater Tank / Supply Device Installing a Regular BottleFreezer Shelves and BinsTempered Glass Shelf Food Storage GuideDoor Bin Plastics DrawerPut eggs in the container and place them on the shelf Can be used to store butter, margarineDoors open. Otherwise, odor and mold may develop CoolSelect zone modelSoft Freeze Select button OptionalChill CoolThaw button Quick Cool buttonDrawers Door binsIce maker bucket optional Front Leg coverCleaning the Accessories Deodorizer optional Changing the Interior LightWithout CoolSelect zoneTM Model Replace the ice maker coverUsing the dispenser without the water filter Water Filter Indicator lightOrdering replacement filters Water FilterSelecting the Location for the Refrigerator Installation of the RefrigeratorChecking the Dimensions of your Entrance Door Removing the Front Leg Cover Optional Removing the Front LEG CoverRemoving the Freezer Door Removing the Refrigerator DoorsRemoving the Refrigerator Door Cover first Reattaching the Freezer DoorOn the front part of the upper hinge 12 Hinge cover first Reattaching the Refrigerator Door Reattach it from the front part of the upper Reattaching the Front Leg Cover Optional Reattaching the Water Tube OptionalLevel the refrigerator Please level the refrigerator firstDoors will be uneven if the refrigerator is not level When you turn clockwise , the door goes up Please open the doors and adjust the doors as followsIf the door of freezer is higher than that Until the lower end of the bolt, then tightenPurifier Checking the PartsSealing tape Clip a x 8EA Tapping screw x 12EA Water line StationCheck the water supply line Connecting to water supply lineConnect the water line to the refrigerator Secure the water line Install the water filterRemove the compressor cover of the refrigerator Cover, locking the filter in postion. Do not overtightenDegree Connect to the water supply lineSecure the water line Connect the water line to the refrigeratorCheck the amount of water supplied to the ice tray Remove any residual matter inside the water supply lineTroubleshooting English
Related manuals
Manual 36 pages 24.01 Kb Manual 38 pages 55.61 Kb
Top Page Image Contents