Samsung RS21DJPS1/XET Connecting to water supply line, Connect the water line to the refrigerator

Page 30

INSTALLING OF THE WATER DISPENSER LINE

For Interior Model (Case 1)

Connecting to water supply line

- Shut off the main water supply line and turn the Ice maker to the off position.

- Locate the nearest cold drinking water line.

- Follow the instructions in the ice maker installation kit.

1.Cold Water line

2.Pipe Clamp. 3.Copper (or Plastic) line 4.Compression Nut 5.Compression Sleeve 6.Shut Off Valve 7.Packing Nut.

Connect the water line to the refrigerator

-Slip the compression nut and plastic ferrule through the plastic tube.

-After inserting the sleeve, tighten the compres-sion nut onto 1/4” compression fitting(union).

Do not overtighten the compression nut.

NOTE

-Slip the compression ferrule and nut on copper(or plastic) tubing as shown.

Tighten the comperssion nut onto the com-pression fitting(union).

- Turn water on and check for any leakege.

Compression

Nut

Ferrule

Sleeve

Compression fitting

Ferrule

Compressi on Nut

Waterline must be connected to drinkable water only

NOTE

(Case 2)

Check the water supply line

Connect the water pipe with coupler and tap.

-Close the main water tap.

-Connect coupler “A” to the tap.

-Every join should be protected with sealing tape.

WARRANTY INFORMATION

This water line installation is not covered by the refriger-ator or ice maker manufacturer's warranty.

Follow these instructions carefully to minimise the risk of expensive water damage.

Note:

If the coupler does not fit on the current tap, go

the nearest authorised service dealer and purchase

the right couplers fittings.

CAUTION

The water line must be connect-ed

to the cold water pipe.

If it is connected to the hot water

pipe, it may cause the purifier to malfunction.

COUPLER “A”

TAP

30

Page 29 Page 31
Image 30
Page 29 Page 31
Contents
Side by Side Safety Warnings Any sharp edges may cause personal injury There is a risk of electric shock or fireThis may cause frostbite See which refrigerant is used for your refrigeratorSetting UP the Refrigerator Major FeaturesControl Panel Basic Model Dispenser ModelBasic Model With CoolSelect ZoneTM Dispenser Model With CoolSelect ZoneTMPower Freeze Digital PanelWater Dispenser Temperature ControlIce Dispenser Cold WaterFix the water supply device tightly into the fixing hole Set the locking device to the LockInstalling a Regular Bottle Water Tank / Supply DeviceShelves and Bins FreezerDoor Bin Food Storage GuideTempered Glass Shelf Plastics DrawerDoors open. Otherwise, odor and mold may develop Can be used to store butter, margarinePut eggs in the container and place them on the shelf CoolSelect zone modelChill Select button OptionalSoft Freeze CoolQuick Cool button Thaw buttonIce maker bucket optional Door binsDrawers Front Leg coverCleaning the Accessories Without CoolSelect zoneTM Model Changing the Interior LightDeodorizer optional Replace the ice maker coverOrdering replacement filters Water Filter Indicator lightUsing the dispenser without the water filter Water FilterInstallation of the Refrigerator Checking the Dimensions of your Entrance DoorSelecting the Location for the Refrigerator Removing the Front LEG Cover Removing the Front Leg Cover OptionalRemoving the Refrigerator Doors Removing the Freezer DoorRemoving the Refrigerator Door Reattaching the Freezer Door On the front part of the upper hinge 12Cover first Reattaching the Refrigerator Door Reattach it from the front part of the upperHinge cover first Reattaching the Water Tube Optional Reattaching the Front Leg Cover OptionalPlease level the refrigerator first Doors will be uneven if the refrigerator is not levelLevel the refrigerator If the door of freezer is higher than that Please open the doors and adjust the doors as followsWhen you turn clockwise , the door goes up Until the lower end of the bolt, then tightenSealing tape Clip a x 8EA Tapping screw x 12EA Water line Checking the PartsPurifier StationConnecting to water supply line Connect the water line to the refrigeratorCheck the water supply line Remove the compressor cover of the refrigerator Install the water filterSecure the water line Cover, locking the filter in postion. Do not overtightenConnect to the water supply line DegreeConnect the water line to the refrigerator Secure the water lineRemove any residual matter inside the water supply line Check the amount of water supplied to the ice trayTroubleshooting English
Related manuals
Manual 36 pages 24.01 Kb Manual 38 pages 55.61 Kb
Top Page Image Contents