setting up your refrigerator
Connecting the water line to the refrigerator
1.Remove the cap from water line on the unit and insert compression nut to the water line on the unit after disassembling from provided water line.
2.Connect both water line from the unit and water line in the kit.
3.Tighten the compression nut onto the compression fitting. There should be no gaps between
(A, B & C )
4.Turn water on and check for any leakage.
Loosen a
Remove |
cap |
Water Line |
from unit |
Water Line |
from unit |
No gap |
Only connect the water line to a drinkable water source.
If you have to repair or disassemble the water line, cut off 6.5mm of the plastic tubing to make sure you get a snug,
The maximum inlet water pressure is 0.83Mpa,and the minimum water inlet pressure is 0.15Mpa.
The new
CAUTION Before being used, the leakage in these places should be examined
• Samsung Warranty does not cover WATER LINE INSTALLATION.
• It will be done at customer’s charge unless the retail price includes installation cost.
• Please contact Plumber or Authorized Installer for the installation if needed.
•If Water leakage occurs due to improper installation, Please contact installer.
12_ setting up