Netcam MultiViewer
1. Registration Use this tab to register Netcam.
2. New
Use to register a new Netcam.
1) Click New. The following screen appears.
2)Enter the IP Address, domain Name, TCP
Port No., User Name, and Password for the Netcam you want to connect.
3)Click OK.
4)Netcam is registered in the list of Registration window.
**Registration cannot be complete if the connection is failed or the network is disconnect.
56
Netcam MultiViewer
3.
Use to delete a registered Netcam.
1)Click on the Netcam to be deleted from the list using your mouse.
2)Click Delete. The following message appears.
3)Click “Yes” to delete the selected Netcam. Click “No” to not delete the selected Netcam.
4.
Use to modify the selected Netcam.
1)Click on the Netcam to be modified from the list using your mouse.
2)Click Modify. The following window appears.
3)Modify the registered information (IP Addr, HTTP Port, StartUp, User Name, and Password).
4)Click OK when modifying is complete. Click Close will not modify the registered information.
5)Verify if the Netcam is modified in the list of the Registration window.
*Modification cannot be complete if the connection is failed or the network is disconnect.
5.
Click “Close” button to exit Viewer Setup Mode.
6.
Use this tab to run Viewer Setup.
**If you change Netcam Name using the SNC Installer while the video is connected, the Target Name in Viewer Setup will not change. The Target Name will change when you connect the video by running Netcam MultiViewer again.
57
Video Netcam | Video Netcam |