Samsung SNC-L200P Connecting, Installing, To install on a wall surface concrete and solid wall

2. Connecting

2.1 Connecting

➀Push downward and remove the cover located at the back of Netcam.

➁Connect one end of the Ethernet cable to the router.

➂Connect the other end of the Ethernet cable to the back of Netcam.

➃Connect the power adapter and power cable to the power outlet and then connect them to the back of Netcam.

➄After the power is connected for 1 minute, make sure Netcam lens automatically moves.

➅Close the cover at the back of Netcam.

2.2 Installing

Install directly on the wall or on let it stand on a flat surface as a tabletop type. You may install it where you want by using separate stands, such as wall mount. (However, when using supplementary stands such as a wall mount to install, make sure the stand can be secured to the nuts on the back of the SET.

*Precautions while installing Netcam

-When installing on the wall, make sure the location can withstand more than the SET weight (app. I kg).

-There is a falling hazard after the SET is installed on the wall. Make sure nobody comes close to it.

-The SET is intended or indoor use. Install it in a place where it cannot be reached by rain, water, or with less humidity.

-When installing using a fixed type stand and separate structures, make sure to secure them so they do not become loose from the nuts on the back of the SET.

10

Connecting

2.2.1. To install on a wall surface (concrete and solid wall)

1.Drill two holes (Diameter: 5 mm, Depth: 35 mm) on the installation location using an electric driller. Vertical distance between the two holes should be 35 mm.

*It would be convenient for you to stick the enclosed label template on the installation surface and use it.

2.Insert the enclosed two plastic anchors to the holes (one each) and tighten the screws with a driver.

35mm Depth 35mm Minimum (for Plastic Anchor) 34mm

Ø5mm 2 Hole

*To install on a regular wooden wall, refer to the figure above and tighten two screws with a driver.

3.Remove the cover from the back of the SET. Plug in LAN-CABLE and POWER CORD. Align the two to the groove of the cover, and then close the cover as shown in the figure below.

4.Align two grooves at the back of the SET to the pre-installed screws on the wall and hang the SET. Pull it slightly downward. The installation is complete.

11

Video Netcam SNC-L200 Video Netcam SNC-L200