Netcam MultiViewer
6. OK
Closes the Motion Detection function after applying the settings.
7. Cancel
Closes the Motion Detection function without applying the settings.
To set the Motion Detection function:
1)Select the video you want to set and change for Motion Detection from the screen window where videos are displayed.
2)Click 
“Motion” icon. The following window appears.
3)Select the area for motion detection by clicking the screen.
4)Change the Sensitivity number properly to select the optimum number. (10: Most sensitive)
5)Click “Preset” button to set the sensitivity temporarily.
6)When a motion is detected, the frame will flash in red.
7)Repeat steps 3)~6) to find the proper setting for the video.
8)Check “Enable Motion Detection.”
9)Click OK when setup is complete.
10)Click Cancel if you do not want to apply the settings.
62
Netcam MultiViewer
The procedure for Motion Detection function is as follows:
1)A motion occurs in the video where the Motion Detection function setup is complete.
2)Window cursor flashes in red.
3)
-Record is recorded in the same folder (Alarm) as the Pre/Post Alarm Record.
4)The motion detected is recorded in a Log file. The following information is recorded in the Log file.
-Time, Day, Month, Year of the motion detected
-Target name
-Netcam’s MAC Address on which the motion is detected
-Netcam’s IP on which the motion is detected
-File name of the Pre/Post Alarm Recording. (If you click the file, the video will be played back immediately and you can verify it.)
*Refer to “6.8.7 Log File” for more details.
6.8Player (Playback) 
Use it to Playback, Search, Capture, or Print the recorded videos.
You may verify Netcam status, such as Disconnect, Reconnect, Alarm, Motion, etc.
* You must press Stop or Pause button to go to Viewer during playback or search.
63
Video Netcam | Video Netcam |