Samsung RS23NAMS1/XET manual Connect to the water supply line, Degree

Page 32

INSTALLING THE WATER DISPENSER LINE

For Exterior model

Connect to the water supply line

Connect the water pipe with coupler and tap.

-Close the main water tap.

-Connect coupler “A” to the tap.

-Every join should be protected with sealing tape.

WARRANTY INFORMATION

This water line installation is not covered by the refriger-ator or ice maker manufacturer's warranty.

Follow these instructions carefully to minimise the risk of expensive water damage.

Note:

If the coupler does not fit on the current tap, go

the nearest authorised service dealer and purchase the right couplers fittings.

CAUTION

The water line must be connected

to the cold water pipe.

If it is connected to the hot water pipe, it may cause the purifier to malfunction.

COUPLER “A”

TAP

Select the location where the purifier is to install. (Model with the purifier)

Line outlet

- Cut the water line attached to the purifier to the appropriate place after measuring the distance between the purifier and the

	cold water tap.	SIDE OF PURIFIER	90 degree
	PURIFIER	SIDE OF PURIFIER
	WATER
	- If you wish to reassemble the water inlet	COUPLER	REFERENCE
	and outlet sides of the purifier during purifier	COUPLER	REFERENCE
	and outlet sides of the purifier during purifier

installation, see the reference illustration.

WATER INLET

SIDE OF PURIFIER

Remove any residual matter inside the purifier. (Model with the purifier)

-Open the main water tap to check whether water is running through the water tube on the water inlet side of the purifier.

OUTLET SIDE OF PURIFIER

PURIFIER

- If water does not come out through the line,

check whether the tap is open.

WATER

- Leave the tap open until clean water is running out and any residual matter that built up during

manufacturing has been removed.

WATER LINE

32

Image 32

Contents Side by Side Safety Warnings There is a risk of electric shock or fire This may cause frostbiteAny sharp edges may cause personal injury See which refrigerant is used for your refrigeratorSetting UP the Refrigerator Major FeaturesControl Panel Basic Model Dispenser ModelBasic Model With CoolSelect ZoneTM Dispenser Model With CoolSelect ZoneTMPower Freeze Digital PanelTemperature Control Ice DispenserWater Dispenser Cold WaterFix the water supply device tightly into the fixing hole Set the locking device to the LockInstalling a Regular Bottle Water Tank / Supply DeviceShelves and Bins FreezerFood Storage Guide Tempered Glass ShelfDoor Bin Plastics DrawerCan be used to store butter, margarine and cheese Put eggs in the container and place them on the shelfDoors open. Otherwise, odor and mold may develop CoolSelect zone modelSelect button Optional Soft FreezeChill CoolQuick Cool button Thaw buttonRemoving the Freezer Accessories Cleaning the Accessories Changing the Interior Light Deodorizer optionalWithout CoolSelect zoneTM Model Replace the ice maker coverWater Filter Indicator light Using the dispenser without the water filterOrdering replacement filters Water FilterSelecting the Location for the Refrigerator Installation of the RefrigeratorChecking the Dimensions of your Entrance Door Removing the Front LEG Cover Removing the Front Leg Cover OptionalRemoving the Refrigerator Doors Removing the Freezer DoorRemoving the Refrigerator Door Cover first Reattaching the Freezer DoorOn the front part of the upper hinge 12 Hinge cover first Reattaching the Refrigerator DoorReattach it from the front part of the upper Reattaching the Water Tube Optional Reattaching the Front Leg Cover OptionalLevel the refrigerator Please level the refrigerator firstDoors will be uneven if the refrigerator is not level Please open the doors and adjust the doors as follows When you turn clockwise , the door goes upIf the door of freezer is higher than that Until the lower end of the bolt, then tightenChecking the Parts PurifierSealing tape Clip a x 8EA Tapping screw x 12EA Water line StationConnecting to water supply line Connect the water line to the refrigeratorCheck the water supply line Ferrule Compressi on NutInstall the water filter Secure the water lineRemove the compressor cover of the refrigerator Cover, locking the filter in postion. Do not overtightenConnect to the water supply line DegreeConnect the water line to the refrigerator Secure the water lineRemove any residual matter inside the water supply line Check the amount of water supplied to the ice trayTroubleshooting Ambient Room Temperature Limits

Related manuals

Manual 38 pages 38.22 Kb