Samsung RS23NAMS1/XET manual Remove any residual matter inside the water supply line

Page 34

2) When you press the test button, the ice cube container is filled with water from the water supply tap.

Check the amount of water (see the illustration below). If the water level is too low,

the ice cubes will be small.

This is not a problem with the ice maker CHECK THE WATER

but of the water pressure inLEVEL

the pipe, and occurs frequently. When this problem occurs, contact the dealer service center to check the amount of water supplied.

34

1) Lift up (①) and pull out (➁) the ice maker bucket in the freezer.

INSTALLING THE WATER DISPENSER LINE

Remove any residual matter inside the water supply line

1)Turn on the main water supply & shut-off valve of the water supply line.

2) Run water through the dispenser until the water runs clear	ICE
(6~7 minutes). This will clean the water supply system and
clear air from the lines.

3)Additional flushing may be required in some households.

4)Open the refrigerator door and check if water leaks around the water filter.

WATER

• A newly-installed water filter cartridge may cause water to briefly spurt from the dispenser. NOTE • Before reinstalling the water filter, remove the wine shelf.

Check the amount of water supplied to the ice tray.

ICE MAKER

TEST BUTTON

TOO HIGH

OPTIMUM-

LEVEL

TOO LOW

Image 34

Contents Side by Side Safety Warnings Any sharp edges may cause personal injury There is a risk of electric shock or fireThis may cause frostbite See which refrigerant is used for your refrigeratorSetting UP the Refrigerator Major FeaturesControl Panel Basic Model Dispenser ModelBasic Model With CoolSelect ZoneTM Dispenser Model With CoolSelect ZoneTMPower Freeze Digital PanelWater Dispenser Temperature ControlIce Dispenser Cold WaterFix the water supply device tightly into the fixing hole Set the locking device to the LockInstalling a Regular Bottle Water Tank / Supply DeviceShelves and Bins FreezerDoor Bin Food Storage GuideTempered Glass Shelf Plastics DrawerDoors open. Otherwise, odor and mold may develop Can be used to store butter, margarine and cheesePut eggs in the container and place them on the shelf CoolSelect zone modelChill Select button OptionalSoft Freeze CoolQuick Cool button Thaw buttonRemoving the Freezer Accessories Cleaning the Accessories Without CoolSelect zoneTM Model Changing the Interior LightDeodorizer optional Replace the ice maker coverOrdering replacement filters Water Filter Indicator lightUsing the dispenser without the water filter Water FilterChecking the Dimensions of your Entrance Door Installation of the RefrigeratorSelecting the Location for the Refrigerator Removing the Front LEG Cover Removing the Front Leg Cover OptionalRemoving the Refrigerator Doors Removing the Freezer DoorRemoving the Refrigerator Door On the front part of the upper hinge 12 Reattaching the Freezer DoorCover first Reattach it from the front part of the upper Reattaching the Refrigerator DoorHinge cover first Reattaching the Water Tube Optional Reattaching the Front Leg Cover OptionalDoors will be uneven if the refrigerator is not level Please level the refrigerator firstLevel the refrigerator If the door of freezer is higher than that Please open the doors and adjust the doors as followsWhen you turn clockwise , the door goes up Until the lower end of the bolt, then tightenSealing tape Clip a x 8EA Tapping screw x 12EA Water line Checking the PartsPurifier StationCheck the water supply line Connecting to water supply lineConnect the water line to the refrigerator Ferrule Compressi on NutRemove the compressor cover of the refrigerator Install the water filterSecure the water line Cover, locking the filter in postion. Do not overtightenConnect to the water supply line DegreeConnect the water line to the refrigerator Secure the water lineRemove any residual matter inside the water supply line Check the amount of water supplied to the ice trayTroubleshooting Ambient Room Temperature Limits

Related manuals

Manual 38 pages 38.22 Kb