Samsung WW12K8402OW/ET manual AC6

Page 59

Code

Action

 

 

 

The electronic control needs to be checked.

 

• Check if power is supplied properly.

 

• If the information code remains, contact a customer service

UC

centre.

 

Low voltage detected.

 

 

• Check if the power cord is plugged in.

 

• If the information code remains, contact a customer service

 

centre.

 

 

 

High temperature heating check.

HC

• If the information code remains, contact a customer service

 

centre.

 

 

 

The Water Level sensor is not working properly.

1C

• Turn the machine off, and restart the cycle.

• If the information code remains, contact a customer service

 

 

centre.

 

 

 

Check communications between main and sub PBAs.

AC

• Turn the machine off, and restart the cycle.

• If the information code remains, contact a customer service

 

 

centre.

 

 

 

This message appears when you open the Add Door without

 

pressing Start/Pause. If this happens, do one of the following:

Press the Add Door to close properly. Then, press Start/Pause

DDC, ddC

and try again.

To add laundry, open the Add Door and input laundry. Close the Add Door properly. Then, press Start/Pause to resume operation.

 

The MEMS sensor is not working properly.

8C

• Turn the machine off, and restart the cycle.

• If the information code remains, contact a local Samsung

 

 

service centre.

 

 

 

Check communications between the main and the inverter PBAs.

 

• Depending on the state, the machine may automatically

AC6

returns to normal operation.

• Turn the machine off, and restart the cycle.

 

 

• If the information code remains, contact a local Samsung

 

service centre.

Troubleshooting

English  59 

Untitled-16 59

2017-11-13 ￿￿ 3:12:22

Image 59
Contents WW12K84*2O Washing MachineContents Specifications MaintenanceTroubleshooting Safety information Important safety precautions Critical installation warnings English 7  Critical usage warnings Installation cautionsEnglish 9  Usage cautions English 11  Safety information Critical cleaning warnings Instructions about the Weee What’s included InstallationSpanner Bolt caps Hose guide Drain Installation requirementsElectrical supply and grounding Water supplyFlooring Water temperatureAlcove installation Remove the shipping bolts Step-by-step installationSelect a location Installation Connect the water hose Adjust the levelling feetHold the adaptor and turn part C English 23  Installation Position the drain hose Power onRun Calibration recommended Initial settingsBefore you start Laundry guidelinesDetermine the load capacity Empty pocketsUse a laundry net Prewash if necessaryApply a proper detergent type Detergent drawer guidelines To apply washing agents to the detergent drawer To use liquid detergent applicable models only Control panel OperationsTo change the cycle during operation Simple steps to startStandard cycles Cycle overviewDelicates Specialty cycle Options Delay End AddWash Special featuresEco Check Child Lock SettingsEasy Connection BrightnessSound LanguagePreparation Samsung Smart Home appUsing the Samsung Smart Home app Wi-Fi connectionSamsung Smart Home Washing Machine app ECO Drum Clean reminder MaintenanceEco drum clean Smart Check Emergency drain Add Door CleaningSurface of the washing machine Mesh filter Pump filter Detergent drawer Care against an extended time of disuse Recovery from freezingCheckpoints TroubleshootingEnglish 55  Change as the automatic temperature control feature checks Information codes Make sure the drain hose is not clogged AC6 DC1 Fabric care chart SpecificationsProtecting the environment Specification sheet Specifications Information of main washing cycles Memo Untitled-16 Netherlands
Related manuals
Manual 68 pages 40.72 Kb Manual 2 pages 36.63 Kb Manual 1 pages 47.32 Kb Manual 1 pages 49.74 Kb