TROUBLE SHOOTING
WARNING
To avoid risk of electrical shock, personal injury or death; disconnect power to dryer before servicing, unless testing requires power.
No | Problem | What To Do |
| |
|
|
| ||
|
| If the igniter does not heat up, remove power and using an | ||
|
| ohmmeter, check the following: |
| |
|
| • | Open flame sensor |
|
8 | The igniter does not | • | Open igniter |
|
glow | • | Shorted booster coil |
| |
|
| |||
|
| • | Open wiring |
|
|
| • Bad motor switch ( Neutral supply) |
| |
|
| • No power from control ( L1 supply) |
| |
|
| If the igniter heats up but the main burner flame is not ignited, | ||
|
| remove power and using an ohmmeter, check the following: | ||
9 | Igniter glows - No gas | • | Open secondary coil |
|
ignition | • | Open holding coil |
| |
|
| |||
|
| • | Open wire harness |
|
|
| • | Stuck flame sensor (Stuck closed) |
|
|
| If a normal ignition takes place and after a short while the flame goes | ||
|
| out, check for the following: |
| |
| The gas is ignited but | • | Radiant sensor contacts opening prematurely. |
|
10 | the flame goes out | • | Weak gas valve coil may open when stressed by higher Temps. | |
|
| • Weak |
| |
|
| • | Poor venting |
|
|
| • | Bad drum seals |
|
|
| • | Lint filter is not clean. |
|
|
| • | Restriction in exhaust. |
|
|
| • Outside exhaust hood damper door stuck closed. | ||
| Improper drying | • | Exhaust too long, too many elbows, flex ductwork installed. | |
11 | clothes wrinkled | • | Poor intake air available for the dryer. |
|
Rough texture long | • | Incorrect tumbler speed. Tumbler belt slipping. | ||
| dry time | • | Blower impeller bound; check for foreign material in blower area. | |
|
| • | Customer overloading dryer. |
|
|
| • Check clothing labels for fabric content and cycle selected. | ||
|
| • | Clothes too wet due to insufficient spin out by | washer. |
|
| • | Thumping Check for loose tumbler baffle, rear | tumbler roller(s) |
|
|
| worn or misaligned, | |
|
|
| tumbler. |
|
|
| • Ticking Check for loose wire harness or object caught in blower | ||
12 | Noisy and/Or | • | wheel area. |
|
Vibration | Scraping Check for front or rear bulkhead felt seal out of | |||
|
|
| position or worn tumbler front bearings. |
|
|
| • Roaring Check for blower wheel rubbing on blower housing or | ||
|
|
| bad motor bearings. |
|
|
| • Popping or squealing sound. Check for a sticky or frayed belt. | ||
|
|
|
|
|
|
|
| 7 |
|