Before
Calling for Service
|
|
|
|
|
|
| Symptom |
| Check |
| Remedy |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
|
|
|
| ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
GB
Symptom |
| Check |
| Remedy |
|
|
|
|
|
Can't turn it on.
It does not work when the button is pressed.
Sound is not produced.
Picture does not appear when the function is selected.
Remote controller does not work.
The sound from each device is changed during stereo playback.
Can't receive radio
broadcasts.
•Is the power code plugged into the outlet?
•Is there static electricity in the air?
•Are the speakers and external components connected properly?
•Is the Mute function on?
•Is the volume set to minimum?
•Is the speaker setup set incorrectly to NONE?
•Is the external component connected properly?
•Are the batteries drained?
•Is the distance between remote control and main unit proper?
•Are the left/right speaker or left/right input/output cables connected properly?
•Is AM or FM antenna connected properly?
•Connect the power plug to the outlet.
•Disconnect the power plug and connect it again.
•Properly connect them.
•Press Mute button to cancel the function.
•Adjust the volume.
•Refer to pages 22~23 to select LARGE, SMALL or YES.
•Properly connect it.
•Replace with new batteries.
•Operate at close distance.
•Check the left/right channel and properly connect it.
•Properly connect the antenna.
•If the input strength of antenna connector is weak, install the FM antenna in a place with good reception.
Can't select Dolby Pro Logic
ll Mode.
There is no sound when playing a DTS encoded DVD.
•Is the input signal selected properly? • Select 2 channel Dolby Digital, PCM, and Analog input signal.
• Is Digital input selected? | • Check whether digital external component |
| is properly connected and refer to page 22 |
| to select the digital input. |
Product Protection Function
There is no sound from
surround speakers.
There is no sound from
center speaker
•Is the surround speaker connected properly?
•Is S.SPK (Surround) incorrectly set to NONE in Speaker Setup?
•Is Surround Mode selected to Stereo?
•Is the center speaker connected properly?
•Is C.SPK (Center) incorrectly set to NONE in Speaker Setup?
•Is the Surround Mode selected to Stereo?
•Refer to pages 10~11 to connect it properly.
•Refer to pages 20~21 to select LARGE or
SMALL.
•Refer to pages 30~37 to select other Surround Mode.
•Refer to pages 10~11 to connect it properly.
•Refer to pages 20~21 to select LARGE or
SMALL.
•Refer to pages 30~37 to select other Surround Modes.
Heat Protection
•The Protection function will come on if the main unit or power transformer overheats.
" | " will appear in the display . |
This function will come on:
-If speaker terminal is shorted
-If speaker cable is shorted
If there is no problem when you turn the unit on again after turning it off, “PROTECTION” will disappear from the display and the unit will work properly.
•If PROTECTION appears on the display, check whether the speaker terminal is shorted and then turn on the unit
MISCELLANENOUS
48 | 49 |